






















Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
ULMA I/O Module
Supply Voltage:24V DC
Power Consumption:≤5W (typical)
Bus Interface:ABB ModuleBus
Isolation:1500V AC (I/O to bus)
300V AC (channel-to-channel)
Update Rate:DI/DO: 1 ms
SD821 Power Supply Device
SD821
DISCONTINUED BY MANUFACTURER
POWER SUPPLY
2.5AMP
230VAC IN
24VDC OUT
Digital Input SOE Module
3BSE013210R1
INPUT MODULE
DIGITAL
24 VDC
16 CHANNELS
CURRENT SINKING
(DI830)
RS485 Twisted pair Modem
3BSE018059R1
TWISTED PAIR MODEM
RS485
TC512V1
Tariff Code: 8517620050
Country of Origin: Sweden
AC 800M Processor Module
3BSE018168R1
DISCONTINUED BY MANUFACTURER
PROCESSOR UNIT KIT
Country of Origin: Sweden
Profibus DP-VI Communication Interface Module
PROFIBUS DP PROFIBUS-DPV1 fieldbus interface.
Supervisory functions of I/O ModuleBus
Isolated power supply to I/O modules
OSP handling and configuration
Input power fused
Hot Configuration In Run
HART pass-through
Analog Input Module - RTD
8 channels for RTD
(Pt100, Cu10, Ni100 and Ni120 and resistor) inputs
3-wire connection to RTDs
14 Bit resolution
Inputs are monitored for open-circuit,
shortcircuit and has a input grounded sensor
Distributed Digital I/O Device
DIGITAL I/O MODULE
32 DIGITAL INPUTS
24 VDC
1-WIRE
SCREW TERMINALS / PLUGGABLE
IP20
Measurement Card
SDCS-PIN-51-COAT
Analog Inputs (AI):0–20 mA/4–20mA
PT100/RTD temperature
Channel Capacity: 8/16 channels
Resolution: ≥16-bit ADC
Sampling Rate: up to 1 kHz
Accuracy: ±0.1% of full scale
Operating Temperature: -25°C to +70°C
Humidity: Up to 95% non-condensing.
MB 300 Dual Ethernet Port Kit
Communication Protocol:MasterBus 300 (MB 300)
Ethernet Ports:2 x RJ45 (8-pin)
Transmission Speed:10 Mbit/s
Data Rate:200 Datasets/s
Operating Temperature:Up to 55°C
Protection Class:IP20 (according to EN60529, IEC 529)
Power Consumption:150 mA @ 24 VDC
AI810 Analog Input Module
8 channels for 0...20 mA, 4...20 mA
0...10 V or 2...10 V d.c.
single ended unipolar inputs
1 group of 8 channels isolated from ground
12 Bit resolution
Input shunt resistors protected to 30 V by PTC resistor
Analog inputs are short circuit secured to ZP or +24 V
The input withstand HART communication.
S400 Fieldbus Modem
DSTC452
DISCONTINUED BY MANUFACTURER
ABB
ASEA BROWN BOVERI
MODEM
FSK
FOR SERIAL I/O BUS
COAX
Tariff Code: 8517620050
Country of Origin: Sweden
PM861A Processor Unit Kit
RAM: 512 MB of RAM
Operating Temperature: -5°C to +55°C
Storage Temperature:-25°C to +70°C
Humidity: humidity from 5% to 95%, non-condensing.
Power Supply: 24 VDC
Profibus DP-VI Communication Module Kit
3BSE030220R1
DISCONTINUED BY MANUFACTURER
INTERFACE MODULE
PROFIBU
DP/V1
COMMUNICATION INTERFACE
Analog Output Module
3BSE020514R1
I/ O ANALOG OUTPUT MODULE
8 CHANNEL
20 MA
AO801
Tariff Code: 8538907080
Country of Origin: Sweden
Digital Output Module
3BSE008510R1
I/O OUTPUT MODULE
DIGITAL
16 CHANNEL
0.5 AMP
24 VDC
DO810
Tariff Code: 8538903000
Country of Origin: Sweden
ABB Digital Input Module
3BSE008552R1
DISCONTINUED BY MANUFACTURER
INPUT MODULE DI811 DIGITAL 24VDC
ABB Profibus DP Communications Interface
CI830
COMMUNICATION INTERFACE PROFIBUS -USE 3BSE013252R1
Tariff Code: 8517620050
Country of Origin: Sweden
07DC92 Configurable Digital I/O Module
GJR5251600R0202
DISCONTINUED BY MANUFACTURER
ANALOG I/O
MODULE 8AI
24 VDC
U/I/RTD
8/12BIT+SIGN 1/3-WIRE
CS31

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.