Power Supply:24V DC (±10%)
Power Consumption:5W (typical)
Isolation :1500V AC
Ethernet Ports:2x RJ45
PROFIBUS Port:9-pin D-sub
Ethernet Speed:10/100 Mbps
Data Throughput: Up to 1440 bytes per cycle
Update Time:<10ms (typical)
Number of Connections:Up to 32 simultaneous
Routing Delay:<1ms
Input Voltage:85-264V AC
Frequency Range:47-63Hz (AC input)
Input Current:2.5A @ 115V AC
Power Factor:>0.95 (with active PFC)
Inrush Current:<30A
Output Voltage:24V DC (±1%)
Output Current:12A (continuous)
Power Rating:288W
Ripple & Noise:<150mVpp
Load Regulation;±1%
Supply Voltage:24V DC (±10%)
Power Consumption:15W (typical)
Isolation :1500V AC
Processor:32-bit DSP
Processor:32-bit DSP
Memory:64MB Flash
Digital Inputs:24V DC
Digital Outputs:Relay, 5A
Analog Inputs:0-10V/4-20mA
Number of Channels:16
Input Voltage Range:24-250V DC/AC
Threshold Voltage:18V DC
Input Current:2-5mA @ 24V DC
Isolation:2kV AC
Power Consumption:3W (max)
Supply Voltage:24V DC (±10%)
Power Consumption:20W (max)
Isolation:1500V AC
Digital Inputs:24V DC
Analog Inputs:0-10V/4-20mA,
Processor:Dual-core 32-bit DSP
Control Cycle:25µs (torque control)
Memory:128MB Flash
Processor:Dual 32-bit PowerPC @ 400MHz
Control Cycle:50ms (typical)
Memory:256MB DDR3 RAM
Supply Voltage:24V DC (±10%)
Power Consumption:25W (typical)
Isolation:1500V AC
Supply Voltage:24V DC (±10%)
Power Consumption:18W (typical)
Isolation:1500V AC
Analog Inputs:4-20mA
Digital Inputs:24V DC
Control Accuracy:±0.1% of span
Response Time:<50ms (10-90% step change)
Control Modes:Speed, Load, Pressure
Control Resolution:24-bit
Loop Update Time:250µs
Speed Control Accuracy:±0.01% of setpoint
Torque Control Accuracy:±0.5% of rated torque
Analog Inputs:±10V/4-20mA
Digital Inputs:24V DC
Input Voltage:24V DC (±15%)
Power Consumption:25W (typical)
Processor:Triple 32-bit
Memory:512MB DDR3 RAM
Control Loops:Up to 128 PID loops
Input Voltage:24V DC (±15%) or 120V AC
Power Consumption:35W (typical)
Isolation:2.5kV AC
Power Supply:24V DC (±10%)
Power Consumption:8W (typical), 12W (max)
Isolation:1.5kV AC
ESD Protection:±8kV
Port Configuration:4x RJ45
Data Rate:10/100/1000Mbps
Latency:<50µs per hop
Jitter:<10µs
Protocol Support:PROFIBUS DP-V1
Data Rate:9.6kbps - 12Mbps
Max Stations:125 devices per channel
Process Data:244 bytes
Diagnostic Data:96 bytes per device
Power Supply:5V DC via backplane (±5%)
Power Consumption:2.5W (typical)
Isolation:1500V AC (field-to-logic)
ESD Protection:±8kV
AC Input: 85–264V AC
DC Input: 100–300V DC
Output Voltage: 24V DC
Output Current: 0.5A (500mA)
Power Rating: ~12W
Efficiency: ≥85%
Inrush Current: <20A
Isolation Voltage: 3 kV AC
AC Input: 85–264V AC
DC Input: 100–300V DC
Input Current: 0.2A @ 115V AC
Frequency Range: 47–63 Hz
Output Voltage: 5V DC
Ripple & Noise: <50mV peak-to-peak
Isolation Voltage: 3 kV AC
AC Input: 85–264V AC
DC Input: 100–300V DC
Input Current: 0.15A @ 115V AC
Frequency Range: 47–63 Hz
Output Voltage: 15V DC
Power Rating: 5W
Efficiency: ≥80% (typical)
Inrush Current: <10A
Isolation Voltage: 3 kV AC
Supply Voltage:24V DC (±10%)
Power Consumption:8W (max)
Encoder Inputs:2x (differential RS422)
Resolution:20-bit absolute
Update Rate:4kHz
Robot Bus:DSQC serial link
I/O Connection:16x digital I/O
Model Number: C41-91824
Type: Flow Control Valve
Pressure Class: ANSI 150/300
Flow Coefficient (Cv/Kv): Cv = 12.5
Extended: Up to +400°C
Control Signal: 4–20 mA, 0–10 V
CP451
Processor Module
(for AFV300/AFV400)
This product is a replacement
for CP451-11 Processor Module
-5 - Standard type with no explosion protection
1 - With ISA Standard G3 option
Channels: 16 digital inputs
Rated Voltage: 24 V DC
Input Voltage Thresholds:15–35 V
Input Current: ~5 mA at rated voltage
Voltage Drop (at 500 mA): ≤0.5 V
Leakage Current: ≤0.1 mA
Response Delay: ≤0.5 ms
Power Dissipation (per channel): 150 mW
Operating Voltage: 24 V DC
Input Current: 1.5 A
Output Power: 10 W
Output Frequency: 1 kHz
Operating Temperature: -20°C to +70°C
Humidity Range: 5% to 95% non-condensing
Digital Inputs:24V DC
Control Voltage (Logic Side): 24V DC
High Voltage (Power Side): 3.3 kV
Control Signals: ≤ 5A
Control-to-Power Isolation: ≥ 2500V AC
Main Processor: 32-bit RISC-based CPU
Clock Speed: 200–500 MHz
Operating Voltage: 24V DC (±10%)
Power Consumption: 5–15W
Isolation: 1500V AC
Ethernet/IP:10/100 Mbps
Digital Inputs: 24V DC
Digital Outputs: Channels 4–8
Current Inputs: 0–20 mA / 4–20 mA
Voltage Inputs: ±10 V DC, 1–5 V DC
Voltage Inputs: ±10 V DC, 1–5 V DC
Input Sharing: Supports HART communication
Accuracy: ±0.1% of span
Sampling Frequency: >300 scans/sec
Input Impedance: 250 Ω for current
Group isolation: 200 V RMS
Inter-track isolation: 250 V RMS continuous
PC BOARD
MOTHERBOARD
MAIN PROCESS CONTROL BOARD
K4LCN-based ENIM
converted to UEA hardware.
Note that the LCN NIM, AM, EPLCG, NGand EHB
with C300s can also be migrated
equivalent ELCN UEA nodes
Input Voltage: DC or AC
Output Current: Typically 10-100 A
Operating Temperature: -10°C to +60°C
Overload protection
Over-voltage protection
Under-voltage protection
Temperature protection
PC BOARD
INVERTER DRIVE BOARD
30 KW FOR ACS510 INVERTER
Input Voltage: 24V DC
Power Section Voltage: 380-690V AC
Signal Isolation:2500V AC
Analog inputs:0-10V/4-20mA
Digital I/O:24V DC
Control Voltage: 15 V DC
Protection Voltage: 12 V D
Operating Temperature Range: -20°C to +55°C.
Storage Temperature Range: -40°C to +70°C.
Humidity: 5% to 95% RH
CANopen
Modbus RTU
PROFIBUS DP
Input Voltage Range: 24 V DC
Operating Temperature: -25°C to +70°C
Storage Temperature: -40°C to +85°C
Humidity: 5% to 95% (non-condensing)
Supply Voltage:48 V dc
AC or DC Operation:DC
Power Consumption:40W
Air Flow:600m³/h
Noise Level:69dB
Fan Speed:7000rpm
Sensor Type:PWM, Tachometer
Bearing Type:Ball
Supply Voltage: 24V DC ±10%
Power Consumption: <15W typical
Voltage ranges: ±10V
Current ranges: 0-20mA
Resolution: 16-bit (minimum)
Sampling Rate: Up to 1kS/s per channel
Accuracy: ±0.1% of full scale
Isolation: 1500V AC
Input Voltage: Typically 24V DC
Operating Voltage Range: ±15V DC
Current Consumption:<500mA
Isolation Voltage: 1000V AC
Fiber optic or optocoupled signals
Digital I/O (for control signals)
Logic Side: 5V DC
Isolated Side: 15V DC
Current Rating: Typically <1A
Reinforced isolation:≥2500V AC
High-speed digital signals
Analog inputs:0-10V, 4-20mA
Input Voltage:230V AC
Range: Typically ±15%
Output Voltage:+24V DC
Auxiliary Outputs: ±15V DC
Efficiency: >85%
Isolation: 2500V AC
Terminal blocks for AC input and DC output
Multi-pin headers for control signals
Input Voltage:230V AC
Range: -15% to +10% of nominal
Frequency: 50/60Hz ±5%
Output Voltages:+24V DC (±1%)
Current Ratings:24V DC
Efficiency: >88% at full load
Ripple: <1% of nominal output voltage
Processor: 32-bit RISC processor
Memory:8MB RAM
Power Supply: 24V DC ±10%
Power Consumption: <15W
Operating Voltage Range: 18-30V DC
Screw terminals for power
BNC or ST-type fiber for Infi-net
DB9 or DB25 for serial
RJ45 for Ethernet (if equipped)
Number of Channels: 16 connection points
Isolation: 250V AC
Rated Voltage: 250V AC/DC
Current Rating: 2A per channel
Contact Resistance: <50mΩ
Insulation Resistance: >100MΩ @ 500V DC
Dielectric Strength: 2000V AC (50Hz)
Frequency range: 1Hz-20kHz
Input sensitivity: 50mV RMS minimum
Isolation: 1500V AC between channels
Analog Inputs:4-20mA position
Control Outputs: 4-20mA governor control signal
Power Supply:24VDC nominal
Accuracy: ±0.1% of reading ±1 RPM
DC Bus Monitoring:0–1000V DC typical
Logic Side: +24V DC (±10%)
Gate Drive Side: +15V/-8V
Current Consumption:<500mA
Gate Drive: Peak 2A
Reinforced Isolation: 2500V AC
Working Voltage: 1000V DC
24 V supply current: max. 25 mA
5 V supply voltage: 5 Vdc ± 5%
5 V supply current: max 1.2 A
Output supply voltage: 15—31 Vdc
Output resistance: approx. 1.1 kΩ
Short circuit proof: continuous
Voltage (high): 15—32 Vdc
Voltage (low): <4 V (reverse polarity protected)
Input current: approx. 8mA at 24 Vdc
Output current: 750mA per output
Input Current Range:±10A (direct input)
Output Signal:4-20mA analog output
Analog Output: 4-20mA (load ≤500Ω)
Accuracy: ±0.5% of full scale
Bandwidth: 10kHz (-3dB point)
Isolation Voltage: 2500V AC
Input Voltage: 24V DC
Power Consumption: ≤1.5W
Isolation: 500V AC
Signal Conditioning:16-bit ADC resolution
Analog Input:4-20mA + HART
4-20mA loop drive: ≤500Ω
Communication Speed: 1200 bps (FSK)
Multidrop Mode: Supports up to 15 devices
Power Supply Unit 24/5 Vdc, 16A (conformal coated)
Operating temperature:-5°C-+70°C (+23°F-+158°F)
Storage temperature: -40°C-+85°C (-40°F-+185°F)
Relative humidity: 10-95% (non condensing)
Approvals:CE, TUV, UL, CSA, FM
24 V supply voltage: 24 V DC -15%-+30%
24 V supply current:
< 6 A at 24 Vin (16 A load)
< 7 A at 20.4 Vin (16 A load)
Inrush current: < 5 A at 24 Vin
Hold-up time: < 1ms
Magnetic pickup (MPU) or proximity probe
Frequency range: 1Hz to 10kHz
Input sensitivity: 50mV RMS minimum
Accuracy: ±0.1% of reading ±1 RPM
Analog Output:4-20mA
Load capacity: ≤500Ω
Power Supply:24V DC ±10% (standard)
