ALL MANUFACTURERS

Signal conditioner

Voltage at min. GAP:−1.6 V
Voltage at max. GAP:−17.6 V
Dynamic range:16 V
Output impedance:500 Ω
Short-circuit current:45 mA
Voltage:−20 to −32 V*
Current:−13 mA ±1 mA (−25 mA max.)

Optical ESB Bus Repeater Module

Type: Optical ESB Bus Repeater Module
Bus System: ESB
Connector Type: SC or LC connectors
Operating Voltage: Typically 24 V DC
Operating Temperature Range: -10°C to 60°C (14°F to 140°F)
Power Consumption: Typically low, around 3-5W

Single Board Computer

Processor:Typically powered by a PowerPC 7448
Memory:512 MB to 2 GB DDR2 RAM 
CompactFlash or Solid-State Drive (SSD) 
Bus Speed: 40 MHz
Voltage: Typically  5V DC
Power Consumption: 20-50W
Operating Temperature: Typically 0°C to 70°C (-40°C to +85°C) 
Storage Temperature: Typically -40°C to +85°C.
Humidity: 5% to 95% relative humidity

Point I/O module

Series:POINT I/O
Module Type:Serial Interface Module
Key Switch Position:2
Voltage Range:10-28.8 volts DC
Supply Voltage:24 volts DC nominal
Supply Current:15mA at 24 volts DC

MBUS+ PROG BRIDGE

Communication port protocol:Modbus Plus
Communication port support:RS232
Modbus Plus bridges and repeaters 
characteristics:Programmable
Bridge
Mounting support:Panel Enclosure
Number of port:4
Rated supply voltage:115...220 V AC 24 V DC

SSI Module

Product Description:Serial Synchronous Interface (SSI) module
SSI Channels:1
Product Family:1734 POINT I/O
Supply Voltage:10-28.8 Volts DC
Part Number:1734-SSI
POINTBus Current:110 milliamps
Power Dissipation:0.94 Watts
No of SSI channels:One (1) SSI port
Supply current :110mA @ 24V dc
Operating Temperature:-20 to 55oC (-4 to 131oF)
Storage Temperature:-40 to 85°C (-40 to 185°F)

ACTUATOR

MODUTROL IV MOTOR
NON-SPRING RETURN
FOOT MOUNTED
4-20 MA MODULATING CONTROL SIGNAL
160 DEGREE STROKE
15-30 SECONDS TIMING
8.5 NM / 75 LB-IN TORQUE RATING
15 VA
120 VAC
50/60 HZ

INVERTER POWER BOARD

INVERTER POWER BOARD
LOW VOLTAGE CONVERTER
INPUT: 0.7 AMP 320-1244 VDC
OUTPUT: 3 AMP 32 VDC 180 W
IP00

3300 XL NSv Proximity

3300 NSv Probe
M8X1 thread, witharmor
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals

8mm Eddy Current Sensor

Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@ 
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@ 
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)

mm Eddy Current Sensor

Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@ 
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@ 
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)

TELEPERM XP FUM 210 MODULE

Part Number: 6DP1210-8AC
System: TELEPERM XP
Input Voltage: 24 V DC
Power Consumption: 15 W
Operating Temperature: -5°C to 45°C 

Digital Input Module

DIGITAL INPUT MODULE
24VDC
SOURCE
64 POINT

Driver board

Input Voltage Range: Typically 24V DC
Output Voltage Range: Dependent on the connected load 
Current Rating: Up to 10A 
Power Rating: Typically around 240W 
Operating Frequency: 1kHz to 20kHz

Expansion Module Safety Relay

440REM4R2
EXPANSION MODULE
GUARDMASTER
GSR EM
MONITORING SAFETY RELAY
1 SINGLE WIRE SAFE INPUT
1 NC SOLID STATE AUX OUTPUT
24 VDC SUPPLY

SAFETY RELAY

440RS12R2
SAFETY RELAY
GUARDMASTER
SINGLE INPUT
1 DUAL CHANNEL UNIVERSAL INPUT
1 N.C. SOLID STATE AUXILIARY OUTPUTS
24 VDC 2.5 W SUPPLY
AC15 250V / 1.5 AMP
DC13 24V / 2 AMP OUTPUT
REPLACES 440R-J23106

POINT I/O Terminal Module

Part Number/Catalog No.:1734-CTM
Series:POINT I/O
Module Type:Terminal Module
Isolation Voltage:250 Volts Continuous
Field Power Supply:1-28.8 Volts DC or 12/240 Volts AC
Field Power Supply Current:4 amps/module

Compact 5000 analog input module

Overvoltage protection, max:± 30V DC
Overcurrent protection, max:±30 mA
Open circuit detection time:2 seconds
Module Keying:Electronic
Number of Inputs:8 Differential Inputs
Number of Outputs:N/A
Voltage Category:N/A
Input Voltage Range:+/- 10 Volts, 0-10 Volts, 0-5 Volts
Output Voltage Range:N/A
Power Dissipation:2.1 Voltage Mode and 2.4 Current Mode
Enclosure Type:None (Open Style)

Guard Locking Proximity Inputs Safety Relay

Product Type: Safety Relay
Model Number: 440R-GL2S2P
Series: Guardmaster
Input Voltage: 24V DC
Voltage Tolerance: -15% to +10%
Current Consumption: Approx. 200mA
Power Consumption: Typically 4.8W
Relay Output Type:
Safety Outputs: 2 NO
Auxiliary Outputs: 1 NC 

SMC Flex Smart Motor Controller

Product Line:SMC-Flex
Part Number/Catalog No.:150-F43NBD
Bulletin Number:Solid-State Controller
Controller Ratings:480 Amps, 
400 Horsepower at 460 Volts AC
Input Line Voltage:200 to 460 Volts AC
Control Voltage:120 / 240 VAC
Rated Voltage:500 to 575 Volts AC

IGBT MODULE

INVERTER TRIGGER DRIVER BOARD
PROTECTION
Rated Voltage (V_CE):650V
Rated Current (I_C):70A
Peak Current (I_C_peak):Up to 180A
Power Dissipation:150W to 300W
Switching Frequency:Up to 20 kHz
Thermal Resistance (R_thJC):1.5°C/W to 2.5°C/W
Junction Temperature (T_j):-40°C to 150°C 

SQ Controller

Local Bus Power +5 VDC at 1.4 A
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 
AirborneContaminants Class G3

Digital DC Sinking Output Module

Series:POINT I/O
Module Type:Digital DC Sinking Output Modules
Outputs:8
Output Voltage:24 Volts DC
Electronically Protected:Yes
POINTBus Current:75 milliamps
Output Current:3 amps/module
Power Dissipation:2 Watts

INTEGRATED MEASUREMENT INTERFACE BOX

7KE3188
INTEGRATED MEASUREMENT INTERFACE BOX
19.5 V
3 AMP
A5E01614931
40-Pin Male Header 0.1" 2.54mm Breadboard

DIGITAL OUTPUT MODULE

SIMATIC S5 440 
DIGITAL OUTPUT MODULE 
NON-FLOATING F
S5-90U/-95U/-100U
ET 100U, ET 200U
4 OUTPUTS 24V DC; 0.5A