
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Digital Output Module
Operating Voltage:380V AC
Input Frequency:50/60Hz
Processing Speed:120 MIPS
Memory Capacity:1MB RAM, 16MB Flash
Communication Interfaces:Ethernet, DeviceNet, FF
Communication module
Manufacturer: Triconex
Model: 7400195-210
Type: Communication Module
Operating Temperature: 0°C to +60°C (32°F to 140°F)
Storage Temperature: -40°C to +85°C (-40°F to 185°F)
Humidity Range: 5% to 95% RH
Dido Panel Module
Dido Panel
7400143-530
Rev A/ A1
Model: 9853-6xx
Volt: 4-20 Ma
8-320 Ma
3000400-530
Rev A
Typ/type: Umk-se 11,25-1
Weight : 150 Gm
Relay Output Module
Communication Protocol:Modbus TCP/IP, DeviceNet
Data Rate:Up to 1 Mbps
Power Consumption:L ess than 4W
Operating Temperature:-40C to +70°C
Mounting Type:Panel Mount
Analog Output Module
Points:4, commoned-return, DC-coupled
Output current range:
4–20 mA output, controlled
0–22 mA over-range
0 mA output capability (step function <2 mA)
Type:TMR
Resolution:12 bits
Diagnostic:Forced-switch diagnostic (FSD)
Over-range protection:36 V DC, continuous
Main Processor (UMP) Module
Power consumption: Typically 15-30W
Operates on 24V DC
Operating Temperature: 0°C to +60°C
Storage Temperature: -40°C to +85°C
Humidity: 5% to 95% non-condensing
Digital Relay Output Module
3636T
DIGITAL RELAY OUTPUT MODULE
32 POINT
2 AMP
125 VAC/DC
1900 VDC POINT ISOLATION
NON-TRIPLICATED
Analog Input Baseplate
Fault current130 mA,
typical200 mA, maximum
Current Input: 4–20 mA, 0–20 mA.
Voltage Input: 0–10 V DC, ±10 V DC
Resolution:16-bit resolution
Accuracy:±0.1% of full scale
Channel-to-channel isolation: 1500 V AC/DC
Operating Temperature:
-40°C to +70°C (-40°F to +158°F)
Storage Temperature:
-40°C to +85°C (-40°F to +185°F)
Power Supply High Density Module
Chassis Type:Main/Expansion/RXM
Nominal Voltage:24 VDC
Input VAC @ 47-63 Hz:n/a
Input VDC:22-31
Fuse Rating and Type:15 amps, time-delay
Output Hold Time:2.8 ms minimum
Diagnostic Indicators:PASS, FAULT, ALARM, TEMP,BAT LOW
Network Communication Module
Input Voltage: 24 VDC
ower Consumption: 5 W
Modbus TCP/IP
Ethernet/IP
OPC (as applicable)
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.