Gate Driver Board
Input Voltage Range: 15-30V DC Output Drive Voltage: +15V/-8V Peak Output Current: ±20A Isolation Voltage: 2500V AC Propagation Delay: <100ns Compatible IGBTs: 1200V-1700V Gate Resistor Range: 1-10Ω Input Signal: TTL/CMOS compatible
Safe line-monitored digital input module with earth fault monitor (16 channels) (conformal coated)
Control Module
Operating Voltage: 24V DC (±10%) Power Consumption: 5–10W Isolation: 1500V AC CPU: 32-bit RISC-based processor Clock Speed: 100–200 MHz Memory Flash:16–32 MB Digital I/O: 24V DC
Circuit Board
Supply Voltage: 24V DC (±10%) Power Consumption: 15W (typical) Operating Current: 0.5-1A Isolation Voltage: 2000V AC Main Processor: 32-bit DSP or microcontroller Clock Speed: 100-200MHz
Velomitor XA Piezo-Velocity Sensor
Sensitivity:3.94mV/mm/s (100 mV/in/s)±5% VelocityRange:1270 mm/s (50 in/s) peak Transverse Sensitivity:Less than 5% of sensitivity Amplitude Linearity:±2% to 152 mm/s (6 in/s) peak MountingTorque:45 N-m (33 ft-lb) maximum
Inverter Drive
IGCT MODULE
Voltage Rating:4500V (VCES) Current Rating:4000A (IT(RMS)) Max. Turn-off Current:6000A (ITGQM) On-State Voltage Drop:1.85V (typical @ 4kA) Switching Frequency:Up to 500Hz Gate Driver Voltage:±20V (isolated)
