Category: Motor Drivers
Stepper Motor: Supports two-phase or three-phase stepper motors
Operating Voltage Range: 24V DC to 48V DC
Max Output Current: 5A continuous current, each phase supports different current settings
Power Consumption: Typical power consumption is about 20W
Operating Temperature: -20°C to+50°C
Storage Temperature: -40°C to +85°C
Number of Input Channels: 8
Input Signal Type: 0 to 20 mA
Resolution: 12-bit
Input Impedance: 250 Ω
Nominal Input Current: 0 to 20 mA
Input Voltage Drop: Maximum 5V
Scanning Time: 10 ms per channel
Accuracy: ±0.1% of full-scale range
Isolation: Galvanic isolation between channels and system
Power Consumption: Typically 1.5 W
Operating Temperature: -25°C to +70°C
Manufacturer:GE Fanuc
Series:Series 90-70
Part Number:IC697CPM790
Number of Installation Slots:1
Number of LEDs:4
Product Type:CPU
Serial protocol support:RS485
Communication Route:Through the Backplane
Emergency Shutdown Functions:Supported
Standalone C Program:Required
Configurable Program and Data Memory:Supported
Specialty function:Triple Modular Redundancy (TMR)
Manufacturer:GE Fanuc
Series:Series 90-30
No. of CPU slots:One (1)
Part Number:IC693CHS397
Number of Slots:5
Default rack address:Rack number 0
No. of I/O slots:Four (4)
Slot 1 assignment:CPU / Specialty modules
I/O Expansion Bus Connector:1
Mounting:Panel Mounting
Installation Rack:Rack 0
Current load:270 mA
P/S Slot:Power Supply Module
Bus voltage:+5VDC
