







3300 NSv Proximity Probes
330905 3300 NSv Probe
M10X1 thread,without armor
Minimum unthreaded length:00 mm
Minimum length: 130 mm
10 1.0 meter (39 in)
12 Miniature coaxial ClickLoc connector
FluidLoc cable
3300 XL Proximitor Sensor
3300 XL Proximitor Sensor
11 1.0 meter (3.3 feet) system length
51 5.0 meters (16.4 feet) system length
91 9.0 meters (29.5 feet) system length
05 CSA, ATEX, IECEx Approvals
3300 XL Proximitor Sensor
Sensitivity: 7.87 V/mm (200 mV/mil) ±5%
Output Signal: -2V to -18V DC
Frequency Response: 0 to 10 kHz (±1dB)
Linearity: ±1% of full scale
Power Supply: -18V to -24V DC
Probe Length: Varies by application
Interconnect Cable
3-conductor shielded 22 AWG (0.5mm2)
armored cable
with 3-socketplug at one end
terminal lugs at theother end
Minimum length of 3.0 ft(0.9 m)
maximum length of 99 ft (30m)
Velomitor Piezo-velocity Sensor
02 M8 x 1
Sensitivity3.94mV/mm/s (100 mV/in/s)±5%.
Velocity Range 1270 mm/s (50 in/s) peak
AmplitudeLinearity±2% to 152 mm/s (6 in/s)peak
MountedResonantFrequencyGreater than 12 kHz.
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 50 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
Vibration Monitor
Monitor with 4-20 maOutputs
02 Multiple Explosive Atmosphere Certifications
Frequency response:10 Hz to 3000 Hz ±5%
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 60 mm
90 9.0 meters (29.5 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.