ALL MANUFACTURERS

Digital output module

16 channels for 24 V d.c.
Redundant or single configuration
Output status indicators
Advanced on-board diagnostics
Degraded mode for normally energized channels 

Control Module

I/O Capacity:16 digital inputs (24V DC)
Processing Speed: 1ms scan time (typical)
Memory: 64KB SRAM 
Power Supply:24V DC (±10%)
Consumption: 5W (typical)
Isolation:1500V AC (channel-to-channel)

Circuit Board

Input Voltage: 24V DC (±10%)
Power Consumption: 5W–10W (typical)
Isolation: 500V AC (channel-to-bus)
Processor: DSP or FPGA-based 
Flash: 8MB–16MB
Digital I/O: 8–16 channels
DeviceNet or Profibus
RS-232/RS-485

SM RIO Module

A metal profile
Two plastic cover plates
A ground rail with 16 ground connection screws
Two power rails with M5 holes (+24 V and 0 V)
Eight mounting holes (6.35 mm diameter)

Overvoltage and undervoltage relay

Rated voltage:250 V ac/dc.
Carry continuously 5 A
Make and carry for 0.5 s 30 A
Make and carry for 3 s 15 A
Terminals 65-66, 68-69

AIN-120 Analog Input Block

AIN-120 Analog Input Block
Input Channels: 16 single-ended/8
Voltage: ±10V, 0-10V, 1-5V
Current: 0-20mA, 4-20mA
Resolution: 16-bit (0.0015% of span)
Supply Voltage: 24V DC (±10%)
Power Consumption: 3.5W (typical)
Inrush Current: <2A for 20ms
Sampling Rate: 10ms/channel (max)

Power drive board

Input Voltage: 3-phase, 380-480V AC
Output Current: Up to 30A
Switching Frequency: 2-16 kHz

Circuit Board

Operating Voltage: 24V DC (±10%)
Power Consumption: 15W typical
Signal Isolation: 2500V AC 
Switching Frequency: Up to 20kHz 
Gate Drive Outputs:±15V gate drive voltage