ALL MANUFACTURERS

Point I/O module

Series:POINT I/O
Module Type:Serial Interface Module
Key Switch Position:2
Voltage Range:10-28.8 volts DC
Supply Voltage:24 volts DC nominal
Supply Current:15mA at 24 volts DC

MBUS+ PROG BRIDGE

Communication port protocol:Modbus Plus
Communication port support:RS232
Modbus Plus bridges and repeaters 
characteristics:Programmable
Bridge
Mounting support:Panel Enclosure
Number of port:4
Rated supply voltage:115...220 V AC 24 V DC

SSI Module

Product Description:Serial Synchronous Interface (SSI) module
SSI Channels:1
Product Family:1734 POINT I/O
Supply Voltage:10-28.8 Volts DC
Part Number:1734-SSI
POINTBus Current:110 milliamps
Power Dissipation:0.94 Watts
No of SSI channels:One (1) SSI port
Supply current :110mA @ 24V dc
Operating Temperature:-20 to 55oC (-4 to 131oF)
Storage Temperature:-40 to 85°C (-40 to 185°F)

ACTUATOR

MODUTROL IV MOTOR
NON-SPRING RETURN
FOOT MOUNTED
4-20 MA MODULATING CONTROL SIGNAL
160 DEGREE STROKE
15-30 SECONDS TIMING
8.5 NM / 75 LB-IN TORQUE RATING
15 VA
120 VAC
50/60 HZ

INVERTER POWER BOARD

INVERTER POWER BOARD
LOW VOLTAGE CONVERTER
INPUT: 0.7 AMP 320-1244 VDC
OUTPUT: 3 AMP 32 VDC 180 W
IP00

3300 XL NSv Proximity

3300 NSv Probe
M8X1 thread, witharmor
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals

8mm Eddy Current Sensor

Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@ 
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@ 
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)

mm Eddy Current Sensor

Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@ 
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@ 
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)

TELEPERM XP FUM 210 MODULE

Part Number: 6DP1210-8AC
System: TELEPERM XP
Input Voltage: 24 V DC
Power Consumption: 15 W
Operating Temperature: -5°C to 45°C 

Digital Input Module

DIGITAL INPUT MODULE
24VDC
SOURCE
64 POINT