ALL MANUFACTURERS

CONTROL CIRCUIT BOARD

Input Voltage: +5V, +12V
Current Consumption: Typically under 2A
RS-232/RS-485
Operating Temperature: 0°C to 50°C.
Storage Temperature: -20°C to 70°C.
Relative Humidity: 5% to 85% (non-condensing)

Traction Voltage Sensors

Nominal primary voltage:2000V r.m.s
Measuring range:±3000
Primary turn number:20000
Secondary turn number:2000
Secondary current at UPN:50
Accuracy at UPN:≤±1
Offset current:≤±0.3
Linearity:≤±0.1
Thermal drift coefficient:-25 … +70°C ≤±5 

POWER MODULE

Support for 10 Mbps Ethernet trunk Fieldbus
Support for DIN rail mounted FBMs
Optional redundancy
Compact, rugged design
Easy to install and configure

Analog Output 24V IOTA Module

Typically 24V DC or 12V DC
Output Type Source 
Load Voltage 15 30 VDC Maximum
On-State Voltage 24 V (typ), load current @ 0.5A
Off-State Leak Current 5.0 µA (max)
Turn-On/Turn-Off Time 10 ms (max)

Serial Interface Card

Local Bus Power 12 VDC at 300 mA
AmbientTemperature-40°C to +70°C 
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3 

Power Supply Rack

Overvoltage:28V DC
Input Voltage:400-480V AC, 3-phase (±10%)
Output Voltage:24V DC regulated
Output Current:50A (continuous), 60A (peak)
Power Rating:1.2kW (per module)
Efficiency:>93% (at 50% load)
Power Factor:>0.95

70 AS 47b-E Module

Power Supply: 24V DC (±10%)
Power Consumption: 3.5W (typical)
Number of Channels: 8
Current Output Range: 4-20mA
Voltage Output Range: 0-10V
Resolution: 16-bit
Accuracy: ±0.1% of span
Current: ≤750Ω
Voltage: ≥1kΩ

Diode Module

Input Voltage:24V DC nominal
Input Current:3-8mA per channel 
Isolation:1500V AC (field to logic)
Response Time:<1ms (ON/OFF)
Number of Channels:32 
Voltage Rating:1600V (V_RRM)
Current Rating:300A (I_FAVM)
Surge Current:8kA (I_FSM, 10ms)
Forward Voltage:1.25V @ 300A (typical)

Ethernet Communication Module

Connection method Point-to-point
Connector RJ-45
Transmission method Half-duplex
Transmission speed 10 Mbps
Transmission route 100 ohm twisted-pair cable

Miniature Circuit Breaker

AC: 230/400 V
DC: 60 V
Rated Current (Iₙ): 42 A
Rated Insulation Voltage (Ui): 500 V
Rated Impulse Withstand Voltage (Uimp): 6 kV

Rotational ac motor M10

Rated Output:1.8 kW 
Peak Torque:180 Nm (transient, 1 sec)
Rated Torque:60 Nm (continuous)
Rated Speed:1,500 rpm
Max Speed:3,000 rpm
Voltage Rating:400 V AC (3-phase)
Current Rating:4.2 A (RMS, continuous) / 12.5 A (peak)
Feedback Device:Resolver (multispeed, 1x/4x)

SERIES 8 PROFIBUS GATEWAY ASSY, COATED

Interface Module

Range: Typically 4-20 mA
Input Impedance:≤ 10 Ω
Load Capacity: Standard 0-500 Ω
Voltage: 24 V DC 
Test Voltage: Typically 1.5 kV AC
Typical: ±0.1% of full scale 

Non-redundant Controller with 28 mixed onboard I/O (new, ROHS)