3300 XL Proximitor Sensor
90 9.0 meters (29.5 feet)
system length,panel mount
Gap Voltage Output:-2 V to -18 V DC
Vibration Output:±5 V AC peak
Dynamic Range:0–10 kHz
Linearity:±1% over full scale
Vibration Variables:±1% of full scale range
3-wire VoltageMode:10 kΩ
Bias Filter:0.09 Hz 1-pole low-pass
OK Filter: 2.4 kHz 1-pole low-pass
BiasVoltage:-24 V
C6691ICP
DISCONTINUED BY MANUFACTURER
PC BOARD
POWER SUPPLY AND RELAY CARD
6600 SERIES
FOR ICP TRANSDUCERS
BACKPLANE RELAY OUTPUTS
THREE POWER INPUTS
CARD MOUNT
C669124
DISCONTINUED BY MANUFACTURER
PC BOARD
POWER SUPPLY AND RELAY CARD
6600 SERIES
24 VDC OUTPUT
BACKPLANE RELAY OUTPUTS
THREE POWER INPUTS
CARD MOUNT
Analog inputs: 4–20 mA, ±10V
Analog outputs (4–20 mA
Voltage range: ±10V, 0–10V.
Current range: 4–20 mA, 0–20 mA
Digital Inputs:24V DC (±10%)
Relay contacts: 2A @ 30V DC / 250V AC
Operating Temperature: -40°C to +70°C (-40°F to +158°F)
Humidity: 5–95% non-condensing
Temperature monitoring is available in 16 channels.
Temperature inputs can be RTD or TC
Accepts isolated tip thermocouples,
3-wire or 4-wire RTDs
or a combination of
TC and RTD inputs
3300 XL 8 mm Probe
M10 x 1 thread
without armor
10 1.0 meter (3.3 feet)
01Miniature coaxial ClickLocconnector
with connectorprotector, standard cable
00 Not required
3300 XL 8 mm Probe
M10 x 1 thread,without armor
10 1.0 meter (3.3 feet)
01Miniature coaxial ClickLocconnector
with connectorprotector, standard cable
00 Not required
330709 3300 XL 11 mm Probe
M16 x 1.5 thread,without armor
Minimum length:50 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
330101 3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
Minimum unthreaded length: 1.0 in
Maximum case length: 2.7 in
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx Approvals
Linear Measurement Range:2 mm (80 mils)
Initial Air Gap:0.5 mm (20 mils)
Incremental Scale Factor
ISO: 8 V/mm (203.2 mV/mil)
± 5%@ temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line
± 0.025 mm (± 1 mil)@
emperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter:25 mm (0.79”)
