
Control Unit
Category: Control Unit
System Memory: 512 MB - 1 GB
Storage Capacity: 4 GB - 8 GB Flash memory
Digital inputs: 32 channels
Analog inputs: 8 channels
Ethernet Interface: 10/100 Mbps
Operating Voltage: 24V DC
Operating Temperature: -20°C to +60°C
Storage Temperature: -40°C to +85°C
8mm Eddy Current Sensor
Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF) ISO:
8 V/mm (203.2 mV/mil) ± 5%@
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)
TERMINAL BLOCK
Series:PACSystem RX3i
Manufacturer:GE Fanuc
Part Number:IC694TBB032
Product Description:Box style terminal block
Description:Terminal block
Terminals:36
Size:0.5 inches depth
Tightening Torque:7 lb-inch
Stripping length:0.310 inches of 7.87 mm
Wire size:14-26 AWG (solid or stranded)
Mounting:Chassis
Removable:Yes
Wire type:Solid or Stranded wire
ANALOG INPUT HART MODULE
Series:PACSystem RX3i
Manufacturer:Emerson Automation
Part Number:IC695ALG626
Product Description:Non-isolated analog input module
Module Type:Analog Input w/HART comms
HART Protocol:Supported; HART Version 5.0
Current Range:0 to 20mA, 4 to 20mA, ±20mA
Input signals, Current:0-20 mA; 4-20 mA; +/-20 mA;
Humidity:5 to 95%, non-condensing
Internal Power:3.3V: 600mA, 5V: 450 mA
Overvoltage:±60 VDC continuous, maximum
Overcurrent:±28mA continuous, maximum
Open Circuit Detection time:1 second maximum
Autocalibration:Performed during power-up
Analog Input Module
SIMATIC DP
ELECTRONIC MODULE FOR ET 200S
2 AI STAND.I-4DMU 15 MM WIDE
+/-20MA; 13 BIT + SIGN,4 .. 20MA
12 BITFOR 4-WIRE TRANSDUCER CYCLE
TIME 65 MS/CHANNEL
WITHLED SF (GROUP FAULT)
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.