
Controller I/O Termination Assembly
Typically 24V DC or 12V DC
Output Type Source
Load Voltage 15 30 VDC Maximum
On-State Voltage 24 V (typ), load current @ 0.5A
Off-State Leak Current 5.0 µA (max)
Turn-On/Turn-Off Time 10 ms (max)
Processor Board
Type: Dedicated 32-bit
Clock Speed: 80 MHz
Non-volatile Memory (Flash): 16 MB
RAM: 64 MB
Serial/Fieldbus Ports: CAN
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 140 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 50 mm
10 1.0 meter (3.3 feet)
11Miniature coaxial ClickLocconnector
with connectorprotector, FluidLoc cable
00 Not required
MB300E Communication Processor
Voltage: 24 V DC
Power Consumption: ≤ 5 W
Serial Ports: RS-232/RS-485
Ethernet Port: 10/100 Mbp
Fieldbus Support: Profibus DP
Processor: 32-bit RISC-based
Flash Memory: 16 MB
Data Throughput: Up to 10,000 signals
Extension Mounting Panel
Operating Voltage: 24V DC
Current Rating: ~1-5A
Layers: Likely 2-4 layer PCB
Possible RJ45/RS-485
Power Supply Board
AC Input: 85-264V AC
DC Input: 120-370V DC
Frequency: 47-63Hz
Inrush Current: ≤20A
Output Current: 5A
Ripple & Noise: <150mV peak-to-peak
Efficiency: ≥88%
Drive Control Board
Input Voltage: 24V DC (±10%)
Power Consumption: 15W typical
Analog Inputs:0-10V/4-20mA
Digital Inputs:24V DC
Processor: 32-bit DSP
Memory: 16MB Flash
Transformer Module
Voltage Input: 100-120V
Current: 0.1A
Voltage: 57.7V
Frequency: 50/60Hz (±5%)
Accuracy Class: 0.5%
Part Number: 1MRK002247-AHR05
Communication Card
Ethernet: 10/100 Mbps
Input: 24-48V DC
Consumption: 3.5W typical
Isolation: 2.5kV AC
Processor: 32-bit ARM
Memory:64MB Flash
Digital Inputs:24V DC
Communication Card
Ethernet: 10/100 Mbps
Serial (RS485): 300–115,200 bps
Input Voltage: 24V DC
Power Consumption: 4W
Isolation: 2.5 kV AC
Processor: 32-bit ARM
Digital Inputs: 24V DC
CONTROL BOARD
Operating Voltage: 24V DC (±10%)
Power Consumption: ≤10W
Isolation: 1500V AC
Processor: 32-bit DSP
PWM Frequency: 2–16 kHz
CODIRECTIONAL MODULE
Binary Outputs:250V AC
Operating Voltage: 24-48V DC
Voltage polarization:57-120V AC
Current inputs :1A/5A AC
Sensitivity: ≤0.5° phase error
Control Module
Supply Voltage: 24V DC (±10%)
Power Consumption: ≤8W
Isolation: 1500V AC
Digital Inputs:24V DC
Analog Inputs:0–10V or 4–20mA
Relay Outputs: 5A, 250V AC
Processor: 32-bit DSP
PWM Frequency: 2–16 kHz
Processor Unit Relay Card
Operating Voltage: 24V DC
Power Consumption: ≤5W
Isolation: 2.5kV AC
Processor: 32-bit DSP
Memory:64MB Flash
Processor Unit Relay Card
Operating Voltage: 24V DC
Power Consumption: ≤5W
Isolation: 2.5kV AC
Processor: 32-bit DSP
Memory:64MB Flash
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.