





VelocityTransducers
06 0 ±100, 10 Hz (600 cpm)
01 Top Mount (no cable)
10 Circular; M10X1 stud
00 No Approvals
Sensitivity 20 mV/mm/s (500 mV/in/s)
Calibration Load 10 kΩ Terminal
"A" to "B" Outputtaken across pins "A" and "B"
SensitivityTemperatureCoefficient0.2%/°C
CoilResistance 1.25 kΩ ±5%
Locked CoilInductance 125 mH, typical
Operatingand StorageTemperature:
-29°C to +121°C(-20°F to +250°F)
Single Board Computer
Front Panel USB Ports
Front Access Reset Switch
15-Pin SVGA Port
Dynamic Measurement Module
1444DYN0401RA
DYNAMIC MEASUREMENT MODULE
4 DYNAMIC INPUTS
2 TTL SPEED INPUTS
1 RELAY
2-PORT ETHERNET/IP (DLR)
SYNCHRONOUS OR ASYNCHRONOUSDYNAMIC

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.