Freescale™ QorIQ P4080 –
8-core CPU @ 1.5GHz
Serial Rapid IO, PCIe
and 1/10GbE fabrics
Fast dual-channel memory
(up to 8 GB RAM with ECC)
Useable in managed (with MCH)
and unmanaged (without MCH) systems
FLOWMETER MASSFLO
MASS 3000
115/230VAC/ENCLO-IP00
Gas Flow: 0.01 to 1000 kg/h
Liquid Flow: 0.1 to 1000 kg/h
Typical Accuracy: accuracy of ±0.5% of readin
Standard Temperature Range: -40°C to +150°C
Operating Pressure:0 to 100 bar
Analog Output:4-20 mA
Voltage Range: 24 V DC
R/I TRANSMITTER 24VDC 0-20MA
Input for Pt100, Ni100 or Ohm
Sensor cable compensation
Linearised analogue output
24 VDC or universally supplied
Individual 0 and 100% adjustment
DIN rail mounting on a standard 11-pole relay socket
Configuration: Non-isolated thermocouple input
Linear range: 4 to 20 mAdc
Current Output limits: <2 to >40 mA (open TC)
Compliance (supply-voltage): 8 to 50 Vdc
Reverse polarity protection: 350 V peak
Maximum loop resistance: (Supply Voltage - 8V)/20 mA
AC Power:100-240 V AC.
Max. Monitor Connections: 4 indoor monitors
Power Consumption:20-40W
Operating Temperature:
Typically, 0°C to 40°C (32°F to 104°F).
Humidity:
Typically up to 80% relative humidity
Range of Product:Altivar 312
Motor power kW:0.37 kW
Maximum Horse Power Rating:0.5 hp
Supply frequency:50...60 Hz - 5...5 %
EMC filter:Integrated
Apparent power:1 kVA
Maximum transient current:5 A 60 s
Power dissipation in W:41 W at nominal load
Speed range:1…50
Processor Model: PowerPC 600 series
Clock Speed: 200 MHz and 500 MHz
Memory Capacity: 64 MB to 1 GB
Memory Interface: 32-bit or 64-bit
Ethernet: 10/100/1000 Mbp
Input Voltage: 5 V to 12 V DC
Frequency coverage:136–174MHz
Number of channels:Max. 128 Ch/ 8 zones
Channel spacing:12.5/25kHz
Type of emission:16K0F3E, 11K0F3E
Current drain:10.0A
Max. audio:0.7A
Stand-by:250mA
Part Number/Catalog No.:2080-IF2
Product Type:Analog Plug-in Module
Module Type:Analog
Number of Single-Ended Inputs:2
Data Range:0-65535
Repeatability:+/- 0.1%
Update Time:180ms per Enabled Channel
Operating Altitude:2000m
Part Number/Catalog No.:2080-IF4
Product Type:Analog Plug-in Module
Module Type:Analog
Number of Single-Ended Inputs:4
Analog Normal Operating Voltage Range:0-10V DC
Analog Normal Operating Current Range:0-20mA
Data Range:0-65535
Repeatability:+/- 0.1%
Part Number/Catalog No.:2080-OF2
Product Type:Analog Plug-in Module
Number of Single Ended Outputs:2
Analog Normal Operating Voltage Range:10V DC
Repeatability:+/- 0.1%
Series:Micro870
Part Number:2080-L70E-24QBB
Product Type:Programmable Controller
CONTROLLER
PROGRAMMABLE
MICRO 820
12 INPUTS
24 VOLT DC
8 OUTPUTS: 7 RELAY AND 1 ANALOG
0 - 10 VOLT DC
4 ANALOG INPUTS
0 - 10 VOLT DC INPUT
SHARED WITH DC INPUTS
FIXED TERMINALS
Input Voltage: 24V or 120V AC/DC
Input/Output: Multiple I/O interfaces
Operating Temperature: -20°C to +70°C
Humidity: humidity of up to 95% (non-condensing)
Excellent spectral uniformity of ± 0.1 dB
100 dB maximum attenuation
Monitor output option
Ultra-low insertion loss
Ideal for BER testing
Singlemode and multimode
Card type PCIe x16
Graphics memory :128 MB DDR2
Form factor (card/bracket) :ATX/ATX
Carddimensions1:6.6” x 4.38” / 16.76 x 11.13 cm
Connectors :DVI-I x 2
Connector adapters :2 DVI-I to HD15
Max displays per card :2
Process Temperature Range:
-40°C to +150°C (-40°F to +302°F)
Process Pressure Range:
-1 to +40 bar (-100 to +4000 kPa)
Output Signal: 4…20 mA/HART
Power Supply: 14…36 V DC
Protection Rating: IP66/IP68 (0.2 bar)
Wetted Materials: Stainless Steel (1.4435)
Probe Length: Up to 9,000 mm
Rated insulation voltage AC 800 V
Rated impulse voltage/pollution degree 8 kV/3
Nominal system voltage Un AC, 3/(N)AC 0…793 V
Supply voltage USAC 88…264 V
Frequency range US 42…460 Hz
Supply voltage US DC 77…286 V
Frequency range US 42…460 Hz
Sensor: CMOS
Resolution: 26 Megapixels
Pixel Size: Typically 3.45 µm
Operating Temperature: -10°C to +50°C
Storage Temperature: -20°C to +60°C
Power Supply: 12V DC
Product or component type:Communication module
Product compatibility:Lexium 32M
Accessory / separate part destination:Servo drive
Number of addresses:256
Electrical connection:2 connectors RJ45
4 LEDs (green/red) for communication status
Range compatibility:PacDrive 3
Device short name:SH3.....P
Product or component type:Servo motor
Maximum mechanical speed:8000 rpm
rated supply voltage:115...480 V
Network number of phases:Three phase
Continuous stall torque:1.25 N.m at 115...480 V three phase
Continuous power:690 W
Maximum current Irms:5.7 A
Maximum mechanical speed 8000 rpm
rated supply voltage 115...480 V
Continuous stall current 2.9 A
Continuous power 1130 W
Speed feedback resolution 128 periods
Torque constant 0.7 N.m/A at 120 °C
Back emf constant 48 V/krpm at 20 °C
Maximum axial force Fa 80 N
Acceleration Range: ±2g, ±5g, ±10g, or ±50g
Voltage output, typically 0-5V or 0-10V
Supply Voltage: 5V DC or 12V DC
Operating Temperature: -40°C to +85°C
Universal Input Output IOTA
Input Channels 1 16 Channels
Common Mode Voltage, dc to 60 Hz -6 to +5 V peak
A/D Converter Resolution 16 bits
Normal Mode Rejection Ratio, at 60 Hz 19 dB
Normal Mode Filter Response Single-pole RC, -3 dB @ 6.5 Hz
Input Impedance (voltage inputs) > 10 M Ω powered
Input Scan Rate 50 ms
Supports fiber-optic medium
NFPA Class B or Class A operation
Data is immune to all environmental noise
Optical isolation prevents ground loops
High-Speed NFN fiber-optic medium
Fiber type: 62.5/125 micrometers (multi-mode);
50/125 micrometers (multimode),
or 9/125 micrometers (single mode)
Maximum attenuation: 10 dB with 62.5/125 μm cable, 6
Module Type:Central Processing Unit
Number of Slots:1 (Single slot)
Battery-backed memory: 1 Mbyte
Number of Points:12K discrete inputs and outputs
Serial Ports:1 (RS422/485 compatible)
Current Required:3.3 Amps nominal
