
Control Module
RAM: 256 MB
Storage: 128 MB flash memory
for program and data storage
Expansion: Supports external memory expansion
Ethernet Ports: 2 x 10/100 Mbps Ethernet interfaces.
Voltage Range: 24 V DC (18 V to 34 V)
Power Consumption: Max 10W
Digital output module
8 A summation current per module
All outputs with single-channel diagnostics
for short circuit or overload
Extremely short cycle times
Outputs with short circuit protection
Integrated protection for switching inductances
Motion Controller Module
Series:RX3i PacSystem
Part Number:IC695PMM335
Catalog:IC695
No. of Axes:4
No of Master axes:1
Backplane Support:Universal Support
Motion Path Planning:1ms
Number of Slots:1 (single slot)
Position Loop Update Rate:500μs
Controlled Axes/Module:4
FSSB Velocity Loop Update Rate:125μs
Motion Path Planning:1 ms
FSSB Torque Loop Update Rate:62.5μs
Power Consumption at 5 V:0.45 A
Servo Command Interface:Fiber Optic
Power Consumption at 3.3 V:1.1 A
Floating Point:Yes
Rechargeable lithium-ion battery
Rechargeable lithium-ion battery
3.7V, 2,4Ah
Non-restricted
Common recommendations for storage of Li-ion batteries
are at -20° to 25° C and to charge the batteries once
per year to 40% (or 3.75V/cell) of their capacity and
never let them discharge to below 2.0V
Series 8 Header Board
Redundant power distribution
IOLink communication system
Ability to extend power cabinets through connectors
Four connectors for combination power
IOLink cable to IO modules in cabinet
Power Supply XLS 480 W Power Supply
Part Number:1606-XLS480E
Input Voltage:100…240V AC / 110...150V DC
Terminals Spring:Clamp
Output Power:480 W
Signal:DC-OK
Output Current:20 A (@ 24V) /17 A (@ 28V)
POWER SUPPLY MODULE
POWER SUPPLY MODULE
220-240 VAC INPUT
50/60 HZ
1.3 AMP INPUT
5.1 VDC / 7.8 AMP OUTPUT
24 VDC / 1.7 AMP OUTPUT
Analog Input Module
SIMATIC S7-200 SMART
Analog input
SM AR02 RTD
2x AI RTDmodules
SM AR02, AI RTD 2x16 bit
24 V DC Yes; -15 / +20 %
Current consumption, typ. 40 mA
from backplane bus 5 V DC, typ. 80 mA
Power loss, typ. 1.5 W
88TK05 Station- Bus Coupler Module
Supply Voltage:24V DC (±15%)
Power Consumption:1.8W (typical)
Interface:9-pin D-Sub
Bus Termination:Integrated
Bus Protocol:PROFIBUS DP (EN 50170)
Transmission Rate:9.6Kbps to 12Mbps
Address Range:0-125
Max Number of Slaves:125
Electrical Isolation:500V AC
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.