
























MicroLogix and SLC Communication Adaptor
ETHERNET INTERFACE MODULE
ADVANCED INTERFACE CONVERTER
RS-232 TO RS-485 ISOLATOR
DH-485
DF1
120MA
24VDC
VME CONTROLLER CARD
High-speed PowerPC processor
≥1.2 GHz
2–4 GB DDR3/DDR4
8–16 GB Flash memory
Backplane integration with I/O modules
Dual 1 Gbps ports for PROFINET
POWER SUPPLY/MARK VI/WITH-335V
Functional Description:VME Power Supply Module
Product Series:SPEEDTRONIC Mark VI Turbine Control
Manufacturer:GE General Electric
Functional Acronym:RKPS
Instruction Manual:GEI-100567
Input Voltage:125VDC
Output Rating:400W
PCB Coating:Normal Coating
TERMINATION BD., TURBINE
IS200TTURH1B
DISCONTINUED BY MANUFACTURER
PC BOARD
TERMINATION BOARD
TURBINE DEVICES
MARK VI
Primary Trip Terminal Board
Series: Mark VI
Product Type: Terminal Board
Trip Solenoids: 3
Solenoid Rated Voltage/Current: 125 V dc
Solenoid Response Time: L/R time constant is 0.1 sec
Current Suppression: Metal oxide varistor
Control Relay Coil Voltage Supply: 28 V
Flame Detector Supply Voltage/Current: 335 V dc
Flame Detectors: 8
Turbine Emergency Terminal Board
Series: Mark VI
Number of Channels: 6
Power Supplies: 200-250Vac
Operating Temperature: 0°C to 70°C
Operating System: QNX
Number of trip solenoids: 3
Bus voltage: 70 to 145 V d
Shaft Relative Vibration Monitor
Input resistance >100 kΩ
Input voltage range 0 to -22 VDC
Smallest range 0-400 mV
Largest range 0-8000 mV
Nominal voltage -26.7 V
Available current Nominal 20 mA, maximum 35 mA
Permissible load <500 Ω
Accuracy ±1% of full scale
Settling time configurable, 0 to 10 seconds
AC 800M Processor Module
3BSE018168R1
DISCONTINUED BY MANUFACTURER
PROCESSOR UNIT KIT
Country of Origin: Sweden

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.