
PROFIBUS INTERFACE CARD
SSTPB3VME1
DISCONTINUED BY MANUFACTURER
PROFIBUS MODULE
CONTROLLOGIX COMMUNICATION MODULE
(1120140004) NIC
1CHL
ROHS
PB3
HART Analog Output Module (EM)
Number of channels 8
Channel Update Rate 24 mS
Output Range 4 to 20 mA
D/A Resolution 14 bits
Accuracy over Temperature Range 0.25% of Span
Output Loading 4-20mA into 700 ohm load Maximum
HART Analog Output Module (PM)
Number of channels 8
Channel Update Rate 24 mS
Output Range 4 to 20 mA
D/A Resolution 14 bits
Accuracy over Temperature Range 0.25% of Span
SACEPR111P
DISCONTINUED BY MANUFACTURER
OVERCURRENT RELEASE
PROTECTION UNIT
MICROPROCESSOR-BASED
8BIT
LOW VOLTAGE
L / S / I / G
IN=1250AMP
IN/2
Power Supply Module
URRHH
DISCONTINUED BY MANUFACTURER
POWER MODULE
HORIZONTAL UNIT
100-240 V AC
125-250 V DC
UR6DH
DISCONTINUED BY MANUFACTURER
DIGITAL I/O MODULE
HORIZONTAL UNIT
16 DIGITAL INPUTS
UR6UH
DISCONTINUED BY MANUFACTURER
DIGITAL I/O MODULE
HORIZONTAL UNIT
6 FORM A OUTPUTS
4 DIGITAL INPUTS
Digital I/O Module
Number of Digital Inputs: 6 discrete digital inputs.
Configurable for 24 VDC, 48 VDC, or 125 VDC
Logic 0 (Low): 0-3 V.
Logic 1 (High): 15-250 V
Continuous Current Rating: 10 A at 250 VAC or 30 VDC
Operating Temperature: -40°C to +70°C.
Storage Temperature: -40°C to +85°C.
Humidity: 5% to 95% non-condensing
Analog Input Module
INPUT MODULE
CONTACT
EVENT
32 CHANNEL
Channels: 32 analog input channels
Signal Types Supported: 4-20 mA, 0-10 VDC
Signal Conversion: 16-bit ADC
for high-resolution data acquisition
Accuracy: Typically ±0.1%
RTD Input Module
RTD Input Module
10/100 Mbps Ethernet
16 analog input channels (4-20 mA)
24 VDC
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.