
Shaft Relative Vibration Monitor
Input resistance >100 kΩ
Input voltage range 0 to -22 VDC
Smallest range 0-400 mV
Largest range 0-8000 mV
Nominal voltage -26.7 V
Available current Nominal 20 mA, maximum 35 mA
Permissible load <500 Ω
Accuracy ±1% of full scale
Settling time configurable, 0 to 10 seconds
1C31222G01:Relay Output Base - High Power 1C31219G01:Relay Output Logic Module
PLC RELAY OUTPUT
BASE
Current: 2A to 5A
Voltage: Up to 250V AC/DC or 24V DC
AC: Up to 250V AC, 5A
DC: Up to 30V DC, 5A
Operating Temperature Range -10°C to 60°C
Provox I/O Interface
KJ2101X1-BA1 Provox IO Interface Module
Tariff Code: 8517620050
Country of Origin: Thailand
PMOD ASSY, VALVE POSITIONER
Resolution 16-bit resolution
Operating Voltage 24 VDC
Operating Temperature 0°C to 60°C
Storage Temperature -40°C to 85°C
Humidity 5% to 95% non-condensing
Value Positioner
VALVE POSITIONER MODULE
Input Signal:4-20mA + HART
Supply Pressure:1.4-7 bar (20-100 psi)
Air Consumption:<0.01 Nm³/h (0.35 scfh)
Operating Range:0-100% stroke
Accuracy:±0.5% of span
Power supply module
WH12FF
DISCONTINUED BY MANUFACTURER
POWER SUPPLY
OVATION
TWO CHANNEL
24VDC AT 12AMP
12VDC AT 8AMP
DC OUTPUT: 500 WATT MAX
EMERSON 1X00024H01
8-Channel RTD Input EMOD
Number of channels 8
Resolution 12 bits
Guaranteed accuracy
0.10% [0.045 (Rcold/Rspan)]%
Temperature coefficient 10ppm/℃
Input impedance
100 M OHM50 K OHM in power down
Module power 3.6 W typical;
4.2 W maximum
Operating temperature range 0 to 60℃ (32℉to 140℉)
Storage temperature range -40℃ to 85℃ (-40℉ to 185℉)
Humidity (non-condensing) 0 to 95%
Analog IN 4-20 Hart Localbus
12P2532X122
DISCONTINUED BY MANUFACTURER
INPUT MODULE 8CHANNEL
Tariff Code: 8538907080
Country of Origin: Malaysia
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.