
























EPNI Card
NETWORK INTERFACE MODULE
EPNI
TDC-3000
Max Nodes:64 nodes per LCN
Power Supply:+5V DC, ±12V DC
Power Consumption:15W typical
Operating Voltage:120/240V AC, 50/60Hz
UCN PM Power Supply
Isolated Output: 4–20 mA (HART-enabled)
Load Capacity: ≤600 Ω
Accuracy: ±0.05% of span (typical)
Input Impedance: ≤250 Ω
Channel-to-Channel: 300V AC
Humidity: 5–95% non-condensing
Battery Extension Module
BATTERY EXTENSION MODULE
5.1-24 VDC
36-112 MA
30 VDC 100 MA OUTPUT
FOR USE WITH PKS C200 SYSTEM
(51309241-175)
PROCESSOR LOW LEVEL ANALOG MUX
Product type : 32 Inputs
Non CE Compliant Part Number : N/A
CE Compliant Part Number : 51304362-150
IOP Type: Low Level Multiplexer (LLMux)
LLMux Assembles: LLMux IOP Conformally Coated
DIGITAL INPUT BOARD
CCTDIL01
DISCONTINUED BY MANUFACTURER
INPUT MODUAL
DIGITAL
NON/R-6 INCH
24 VDC
Digital Output 24V Module
CCPDOB01
DISCONTINUED BY MANUFACTURER
OUTPUT MODULE
DIGITAL
80 MA
24 VDC
Digital Input 24V Module
CCPDIL01
DISCONTINUED BY MANUFACTURER
DIGITAL INPUT MODULE
SERIES C I/O
DI-24 IOM
32 CHANNELS
95 MA
24 VDC
Analog Input Module
Input Type Current (2-wire or self-powered transmitters)
Input Channels 16 Channels (16 Single Ended)
Common Mode Rejection Ratio, dc to 60 Hz 70 dB
A/D Converter Resolution 16 bits
Input Range 4-20 mA (through 200 Ω)
Normal Mode Rejection Ratio, at 60 Hz 20 dB
Normal Mode Filter Response Single-pole RC, -3 dB @ 6.0 Hz
Maximum Normal Mode Input ± 30 Volts
Fieldbus Interface Module
CCPFB401
DISCONTINUED BY MANUFACTURER
FIELDBUS INTERFACE MODULE
4 LINK
210 MA
24 VDC
Digital Output Module
1020121
DISCONTINUED BY MANUFACTURER
OUTPUT MODULE
DIGITAL
550MA
24VDC
8CHANNEL
FSC/ FAIL SAFE CONTROLLER
Analog Input Module
1010521
DISCONTINUED BY MANUFACTURER
ANALOG INPUT MODULE
24 V
16 CHANNEL
Tariff Code: 8538903000
Country of Origin: United States
Digital Input Module
1010121
DISCONTINUED BY MANUFACTURER
INPUT MODULE
DIGITAL
16CHANNEL
24VDC
Bus Driver Module
1010021
DISCONTINUED BY MANUFACTURER
BUS DRIVER MODULE
HORIZONTAL
Tariff Code: 8517620050
Country of Origin: United States
Central Processing Unit - Flash Memory
1001212
DISCONTINUED BY MANUFACTURER
MODULE CENTRAL PROCESSING UNIT FLASH MEMORY
Watch Dog Module
memory error logic from CPU
COM and MEM modules
The application loop maximum execution time
5 Vdc± 5 %
Run Stop Keyed Module
1000212
DISCONTINUED BY MANUFACTURER
MODULE RUN/STOP KEY SELECTOR FSC
HPM power supply module
POWER SUPPLY
HPM
AC INPUT
AC/DC OUTPUT
100 TO 240 VAC
48 VDC BATTERIES
6 VAC LINE FREQUENCY

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.