
Low Voltage DC PIM
114M5335-01 Low Voltage DC PIM
Input Voltage:10-30V DC
Input Signal:LVDT/RVDT (1-5V RMS, 2.5-10kHz)
Output Signal:4-20mA (fault = 3.8mA or 21mA)
Accuracy:±0.25% FS
Micro Memory Card - 128 KB
MEMORY CARD
SIMATIC S7
N-FLASH
128 KB
3.3 VDC RATING
FOR S7-300/C7/ET 200
Output module
Number of outputs 16, electrically connected
Short circuit protection yes
Total current per module 8 A on 100 % duty cycle
Voltage drop ≤ 0,3 V at 0,5 A
Internal currentconsumption(from V+ bus)0 mA
External currentconsumptionLoad current
Operating mode Source operation
Voltage range 10…32 VDC, smoothed,max. 10 % residual ripple
Wind Turbine Monitor
Input Power:24V DC (±10%) or 100–240V AC
Power Consumption:<20W (typical)
Analog Inputs:4–20mA, ±10V, IEPE (2-wire)
Relay Outputs:4x SPDT (5A @ 250V AC)
Communication:Ethernet, Modbus TCP/RTU
15 inch TFT QuickPanel View/ Fully Loaded/ 24VDC
OPERATOR INTERFACE
QUICKPANEL
VIEW AND CONTROL OPERATOR INTERFACE
15.1 INCH DISPLAY
15 INCH TFT
FULLY LOADED
24 VDC
Pulse Amplification Board
Input Voltage Range:10mV - 30V AC/DC
Input Impedance:100kΩ (typical)
Output Signal:24V transistor / 0-20mA
Output Current:≤500mA (transistor), ≤20mA (analog)
Isolation Voltage:1500V AC
High-gain amplifier: 10-100x adjustable
Wide input range: 10mV to 30V pulses
Frequency response: DC to 500kHz
Isolated output: 24V PNP/NPN or 0-20mA
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.