
Control Module
I/O Capacity:16 digital inputs (24V DC)
Processing Speed: 1ms scan time (typical)
Memory: 64KB SRAM
Power Supply:24V DC (±10%)
Consumption: 5W (typical)
Isolation:1500V AC (channel-to-channel)
Digital Output Module - Relay
SIMATIC S7-300
Digital output SM 322
isolated, 8 DO (relay)
1x 40-pole, 24 VDC, 5 A or 230 V AC, 5 A
connectors with spring-loaded terminal
Seismic Transmitter
0 – 25.4 mm/s (0 – 1.0 in/s)
10 Hz to 1 kHz (600 to 60 kcps)
RMS(Root Mean Square)
Multiple Approvals
(CSA/NRTL/C,ATEX/IECEx)
ExcitationVoltage12 to 30 Vdc
SettlingTimeLess than 15 seconds
within 2%of final value
MountedResonantFrequencyGreater than 12 kHz
TransverseSensitivity Less than 5% of sensitivity
SensingElementTypeCeramic / Shear
UCSB Controller Module
Series: Mark VIe
Function: UCSB Controller
Microprocessor; 600MHz Intel
Memory: 256 MB DDR2 SDRAM
Operating System: QNX Neutrino
Operating voltage: 24 VDC
Operating Temperature: -10°C to +60°C.
Storage Temperature: -40°C to +85°C
Memory:4GB to 16GB RAM
Modbus TCP/IP, Profibus DP
Circuit Board
Input Voltage: 24V DC (±10%)
Power Consumption: 5W–10W (typical)
Isolation: 500V AC (channel-to-bus)
Processor: DSP or FPGA-based
Flash: 8MB–16MB
Digital I/O: 8–16 channels
DeviceNet or Profibus
RS-232/RS-485
MQ Controller
SM RIO Module
A metal profile
Two plastic cover plates
A ground rail with 16 ground connection screws
Two power rails with M5 holes (+24 V and 0 V)
Eight mounting holes (6.35 mm diameter)
3300 XL Standard Extension Cable
085 8.5 meters (27.9 feet)
01 Armored cable
05 CSA, ATEX, IECEx Approvals
Digital Input Module
SIMATIC S7-1500 Digital input module
DI 16x24 V DC BA
16 channels in groupsof 16, input delay typ
3.2 ms, input type 3 (IEC 61131)
frontconnector Push-in
DIGITAL STEAM TURBINE CONTROLLER
PEAK 150 SERIES
2 MAGNETIC PICKUP INPUTS
1 ANALOG INPUT
8 DISCRETE INPUTS
2 ANALOG OUTPUTS
1 ACTUATOR OUTPUT
4 RELAY OUTPUTS
110 VAC
125 VDC
200 HZ
15 KHZ
4-20 MA
NEMA 4X
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.