
Seismic Transmitter
ExcitationVoltage12 to 30 Vdc
MountedResonantFrequencyGreater than 12 kHz
Sensitivity 10.2 mV/m/s2 (100 mV/g) ± 20%
Full ScaleRange 147 m/s2 ( 15 g) peak
Linearity ± 1% of Full Scale
Output Bias 2.5 V ± 0.1 V
OperatingTemperature-40°C to +85°C(-40°F to +185°F)
ElectricalIsolationGreater than 108 ohms
Drive power board
Input Voltage:3-phase 380-480V AC (±10%)
Output Voltages:+24V DC (control)
Power Capacity:500W (continuous)
Switching Frequency:20kHz (PWM)
Efficiency:>92% (at full load)
Control board
Input Voltage:24V DC (±10%)
Power Consumption;25W (typical)
Isolation :1500V AC (field to logic)
Vector control
Torque/speed regulation
PID controllers
Communication;Ports 2x Ethernet, 1x RS-485
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.