
Power output module
SIMOVERT Masterdrives
Power output module
PEU For devices 47 A
510-620 V DC
Power output module
SIMOVERT MASTERDRIVES
MODULE
380-480VAC
50/60HZ
79.2 AMP
37 KWATT
3 PHASE
Control board
Component Type:CUCP
Power Supply:24 VDC
Operating Voltage:24 VDC
Operating Temperature:0°C to +50°C
Storage Temperature:–25°C to +70°C
Control Interface Board
MICROMASTER 440
PX replacement Control Interface Board
for 380-480 V 3AC
50/60 Hz
380 A AC Drive
CONTROL INTERFACE BOARD
SINAMICS S
CONTROL INTERFACE BOARD
FOR 3PH 380-480 V
50/60 HZ, 210 A
MOTOR MODULE
Control Interface Board
SINAMICS S
Control Interface Board
for 500-690V 3AC
50/60 Hz, 1270A
Motor Module
MOTION CONTROL INVERTER
SIMOVERT MASTERDRIVES
MOTION CONTROL INVERTER
COMPACT-PLUS-UNIT
IP20 510-650V DC
25.5A NOM
POWER RATINGS: 11KW
Active Line Module
SINAMICS S120
Active Line Module
Input: 380-480V 3AC, 50/60 Hz, 490 A
Output: 570-720 V DC, 549A
Rated power: 300kW Built-in unit
IP00 Liquid cooling
incl. Drive-CLiQ cable
CONTROL INTERFACE
CONTROL INTERFACE
SINAMICS G REPLACEMENT
605 AMP
380-480 VAC
50/60 HZ
REPLACED BY 6SL3350-6TK00-0EA0
CONTROL INTERFACE BOARD
SINAMICS S
CONTROL INTERFACE BOARD
FOR 3PH 380-480 V
50/60 HZ
210 A
MOTOR MODULE
PLUS Inverter Drive Board
Input Voltage Range:24 VDC
Ambient Operating Temperature:0°C to +40°C
Storage Temperature:-25°C to +70°C
Coordinates motor control signals
Interfaces with IGBT/power modules
Provides fault feedback and protective signaling
CONTROL INTERFACE BOARD
CONTROL INTERFACE BOARD
380 AMP ACTIVE LINE MODULE
3 PHASE
380-480 VAC
50/60 HZ
Power board
Voltage Range:380 – 480 V AC
Frequency:47 – 63 Hz
Output Voltage:Variable
Operating Temperature:0°C to +40°C
Storage Temperature:-25°C to +70°C
PLUS Inverter Power Board
Application:MICROMASTER 430
Phase Input:3-phase AC
Voltage Class:380 – 480V AC
Cooling Method:Forced air-cooled
Ambient Temperature Range:0°C to +40°C
Storage Temperature:-25°C to +70°C
Side exit sensor
Sensitivity:100 mV/g
Accel range:80 g
Frequency Range (3dB):0.5-10,000 Hz
Haz-area rating:Zone 2 rated
Sensitivity: ± 5% @25°C 100 mV/g
Resonant frequency:22 kHz
Acceleration range:80 g peak
Amplitude nonlinearity:1%
Transverse sensitivity, max:±5% of axial
Proximity Probe HousingAssemblies
00 Probe not required
00 Probe cable not required
(Option Amust also be 00)
15 Minimum length 1.5 in (38 mm)
01 One 3/4-14 NPT fitting, two plugs
02 3/4-14 NPT
(Required if orderingStandoff Adapter Option)
3300 XL 8 mm Probe
330103: 3300 XL 8 mm Probe
M10 x 1 thread,without armor
90 9.0 meters (29.5 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
8 mm Standard Mount Probe
Sensing Tip Diameter: 8 mm
Mounting Thread: 3/8-24 UNF
Unthreaded Length: 0.0 mm
Overall Case Length: 240 mm
Total Cable Length: 1.0 meter (39 inches)
Connector Type: Miniature male coaxial connector
Operating Temperature Range: -40°C to +177°C (-40°F to +350°F)
Interconnect Cable
Cable Length: 10 feet
Conductor Size: 18 AWG
Conductor Count: 2 conductors
Cable Type: Twisted, shielded
Temperature Range: -29°C to +121°C
Voltage Rating: 300V AC
Interconnect Cable
Cable Length: 16 feet
Connector Type: BNC Male to BNC Male
Impedance: 75 Ohms
Maximum Voltage Rating: 300 Volts
Operating Temperature Range: -40°C to +85°C
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.