
















PROXIMITY SENSOR
PROXIMITY SENSOR
MODEL: 3300 XL 8 MM
1 M LENGTH
OUTPUT RESISTANCE: 50 O
OPERATING TEMP: -51 C TO +177 C
(060-987-158)
Proximitor Seismic Monitor I/O Module
Series: 3500
Input Signal: -10 Vdc to +10 Vdc
Power Consumption: 10.5 watts
Front Panel: USB-B
Product Type: Proximity Seismic Monitor I/O Module
Ethernet: 100Base-FX Fiber-Optic
Operating Temperature: -30°C to +65°C
Armoured Extension Cable
080 8.0 meters (26.2 feet)
01 Armored cable
05 CSA, ATEX, IECEx Approvals
3300 XL Standard Extension Cable
3300 XL Proximitor Sensor
90 9.0 meters (29.5 feet) system length
05 CSA, ATEX, IECEx Approvals
3300 XL Proximitor Sensor
3300 XL 11 mm Extension Cable
080 8.0 meters (26.2 feet)
01 Armored cable
00 Not required
330104 3300 XL 8 mm Probe
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 80 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx Approvals
General Purpose Equipment Monitor
Vibration Variables:±1% of full scale range
3-wire VoltageMode:10 kΩ
Bias Filter:0.09 Hz 1-pole low-pass
OK Filter: 2.4 kHz 1-pole low-pass
BiasVoltage:-24 V
Recip Cylinder Pressure Monitor
Series: 3500 Series
Standard: 0-5,000 psi (0-345 bar)
Sampling Rate: Up to 100 kHz per channel
ADC Resolution: 16-bit
Power Supply: 24 VDC (±10%)
3300 XL Extended Temperature Range(ETR) Extension Cable
080 8.0 meters (26.2 feet)
01 Armored cable
00 Not require
3300 XL 8mm Proximity Probe
101.0 metre (39 inches)
Tolerance: + .25 mctre, -.10 mctre
(+ 10 inches, . 4 inches)
02 With miniature male coaxial
conncctor
3500/60 I/O Module
Analog inputs: 4–20 mA, ±10V
Analog outputs (4–20 mA
Voltage range: ±10V, 0–10V.
Current range: 4–20 mA, 0–20 mA
Digital Inputs:24V DC (±10%)
Relay contacts: 2A @ 30V DC / 250V AC
Operating Temperature: -40°C to +70°C (-40°F to +158°F)
Humidity: 5–95% non-condensing
RTD/Isolated Tip TC I/O Module
Temperature monitoring is available in 16 channels.
Temperature inputs can be RTD or TC
Accepts isolated tip thermocouples,
3-wire or 4-wire RTDs
or a combination of
TC and RTD inputs

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.