ALL MANUFACTURERS

FTE BRIDGE MODULE

Communication Protocol Ethernet
with fault-tolerant mechanisms
Redundancy Support
Dual redundant communication paths
Input Voltage 24 VDC or 120/240 VAC
Power Consumption Low power, typically under 10 W
Operating Temperature Range  -20°C to +60°C
Storage Temperature Range -40°C to +85°C
Humidity 5% to 95% non-condensing

Sub-D to Knife terminals FTA

37-pole sub-D male connector 
(CN1) that must be connected 
with (16) RUSIO channelsl 16 sets 
of two knife terminals for the sixteen channels
Each channel has a the following knife 
terminal connections:l A+ terminal that is the (RUSIO) 
signal connection.l A- terminal that is 
the common 0 Volt connection.

Earth Fault Monitor

Temperature -40°C to +75°C
(-40°F to +167°F )
Approvals CE, TUV
DIN EN rails: TS32 / TS35 x 7.5
Input voltage:24 VDC +30/-15% 
Input current:10 mA maximum 25 mA
Voltage typically +4.1 VDC
Resistor (R)approximately 2.8 kOhm

SM RIO 36 inch Carrier

Product Type : SM RIO 36 inch Carrier
Operating temperature : -40 .. +70 degC 
Storage temperature : -40 .. +85 degC
Relative humidity : 10..95% (non condensing)
Pollution : Pollution degree 2 or better
Approvals : CE; UL pending

PWA / I/O LINK MODULE

Module Type I/O Link Module 
Power Supply 24 VDC 
Operating Temperature -20°C to +60°C
Storage Temperature -40°C to +85°C
Humidity 5% to 95% non-condensing

Single Board

2x Quad-Core/Dual-Core Intel® 
Xeon® LV Processors
Four SO-RDIMMs for up to 1
6GB REG/ ECC memory
Four PCI-Express Gigabit Ethernet ports
64bit/66MHz PMC/PCI-Express x8 XMC
Onboard SATA HDD, CompactFlash and USB NAND flash storage

POWER SUPPLY

Input Voltage Range
85-264 VAC / 90-350 VDC
Frequency Range 47-63 Hz
Output Voltage 24 VDC (nominal)
Output Current Up to 10 A
Power Output Capacity 240 W
Efficiency ≥ 90%
Ripple and Noise ≤ 50 mV

IS module power supply carrier

IS module power supply carrier 8724-CA-PS
Accommodates one 8920 PSU module
DIN rail or panel mounting
printed wiring board
rugged polycarbonate moulding
32- and 64-slot address capable
CARRIER MOUNTING MODULE: 
System Power Supply module: 8920-PS-DC

DC power supply

8920-PS-DC
Power Module-Field Input
24VDC In
5A@12VDC Out
Power for 2/1 (IS) modules
Use2/1 (IS) 
modules power with 
support for load sharing redundancy

DC power supply

PAC8000 I/O 
Power Module-Field Input24VDC In
5A@12VDC Out; 
Power for 2/1 (IS) modules
Use2/1 (IS) modules power 
with support for load sharing redundancy
PAC8000 Intrinsically Safe module 
DC power supply (8 modules)

RST Analog Termination Board

I/O BOARD ANALOG
MARK 5
TURBINE CONTROL
MULTI INPUT/ OUTPUT
ON BOARD RAM

Digital Input/Output Module

Input Voltage Range 12-24 VDC
Output Voltage Range 12-24 VDC
Output Current Capacity 0.5A to 2A per channel 
Response Time <10 ms for input and output signals
Power Supply 24 VDC
Mounting DIN rail or rack-mountable
Operating Temperature -10°C to 60°C
Storage Temperature -20°C to 85°C
Humidity 5% to 95% non-condensing

Normally Closed Relay Output Block

Series Genius I-O
Part Number IC660BBR100
Product Type Relay Output Block
Output Block Type Normally Closed
Number of Outputs 16
Output Configuration 4 Groups of 4 Outputs Each
Output Voltage Type AC or DC
Power Requirements 87 Milliamps at 115 Volts AC

Normally Closed Relay Output Block

Series Genius I-O
Part Number IC660BBR100
Product Type Relay Output Block
Output Block Type Normally Closed
Number of Outputs 16
Output Configuration 4 Groups of 4 Outputs Each
Output Voltage Type AC or DC
Power Requirements 87 Milliamps at 115 Volts AC

Analog Input Module

Ovation Distributed Control System 
8 to 16 analog input channels
Analog signals 
4-20 mA, 0-10 V
16-bit resolution for high precision
0°C to 60°C

Base Connection Unit

Input Voltage 24 VDC
Mounting Type Rack-mounted or integrated 
within the robot controller system
Connection Types Multi-port connectivity 
for cables and communication modules
Operating Temperature-10°C to 55°C
Storage Temperature -25°C to 70°C
Humidity 5% to 95% non-condensing

I/O Board

Input Voltage Range: 24 V DC 
Current Consumption: 
Depends on the configuration of the I/O channels
Signal Type: Digital
Input Type: 24 V DC 
Output Type: Relay contacts or transistor outputs
Relay Output Rating:  30 V DC / 2 A per relay

CONTROL MODULE

CONTROL MODULE
E300 OVERLOAD RELAYS
193 IEC RELAY
I/O ONLY
6 INPUTS / 3 RELAY OUTPUTS
24 V DC CONTROL VOLTAGE

Overload Relay

COMMUNICATION MODULE
E300 OVERLOAD RELAYS
IEC
DEVICENET
193/592 IEC/NEMA

Analog Input Module

Channels: 15
Signal Types:
standard current input:4-20 mA 
voltage inputs0-5 VDC
Input Range:  0-10 VDC, ±10 VDC, 
Signal Conversion: 16-bit 
Input Impedance: High input impedance f
or accurate measurements without significant loading.
Input Accuracy: Typically ±0.1% 
Operating Temperature:  -20°C to +60°C

Analog output module

Channels: 16 or 32 
current output:4-20 mA 
voltage output:0-10 VDC or ±10 VDC 
Output Range:0-10 V, ±10 V, 4-20 mA
Resolution: 16-bit 
Accuracy:
±0.1% of full scale for voltage outputs
±0.1% of full scale for current outputs

NSv Proximitor Sensor

3300 NSv Probe
3/8-24 UNF thread
withoutarmor
5.0 metre (16.4 feet) systemlength
panel mount 
0 0 Not required

NSv Proximity Sensor

7.0 5.9 ± 0.9
Extension cabledc resistance
Center conductor: 0.220Ω/m (0.067 Ω/ft)
RecommendedGap Setting 1.0 mm (40 mils)
IncrementalScale Factor 7.87 V/mm (200 mV/mil)
OperatingTemperature-52°C to +177°C
StorageTemperature-52°C to +177°C (-62°F to+351°F)

6ES7405-0DA01-0AA0

SIMATIC S7-400
power supply PS 405
4 A, 24/48/60 V DC
5 V DC/4 A

Analog output Module

SIMATIC S7-300
Analog output SM 332
isolated, 2 AO, U/I
resolution 11/12 bits
20-pole
Removing/inserting 
with active backplane bus possible