ALL MANUFACTURERS

DDCS Branching Unit

Protocol: ABB DDCS 
Baud Rate: 12Mbps
Supply Voltage: 24V DC (±10%)
Power Consumption: 10W typical
Isolation: 500V AC
Fiber Type: Multi-mode 62.5/125μm

Submodule Carrier

Supply Voltage: 24V DC (±10%)
Power Consumption: 2W
Backplane Current: 1A maximum per slot
Isolation: 500V AC
System Connection: S800 bus to main controller
Field Connection: Screw terminals for I/O wiring
Bus Speed: 1.5Mbps 

3300 XL Standard Extension Cable

3301300700005
EXTENSION CORD
070 7.0 meters (22.9 feet)
00 Standard cable
05 CSA, ATEX, IECEx  Approvals

3300 XL 8 mm Probe

3300 XL Standard Extension Cable
045 4.5 meters (14.8 feet)
03 Armored cable with connectorprotector
00 Not required

PC I/O BOARD

Number of Channels: 16 or 32 
Input Voltage: 24V DC
Isolation: 500V opto-isolation
Channels: 8 single-ended 
Input Range: 0–10V, ±10V

Velomitor XA Piezo-Velocity Sensor

Sensitivity:3.94mV/mm/s (100 mV/in/s)±5%
VelocityRange:1270 mm/s (50 in/s) peak
Transverse Sensitivity:Less than 5% of sensitivity
Amplitude Linearity:±2% to 152 mm/s (6 in/s) peak
MountingTorque:45 N-m (33 ft-lb) maximum

SIWAREX MS Weighing Module

Interconnect Cable

16710-14  
Interconnect Cable 
3-conductor

Variable Frequency Drive

Power Range: 0.55kW
Low Voltage: 380-480V AC
Medium Voltage: 500-690V AC
Input Frequency: 47-63Hz
Output Frequency: 0-300Hz 
Overload Capacity: 110% continuous
Digital Outputs: 3 relay (2A/250V AC)
Analog Outputs: 2 (0/4-20mA or 0-10V)

Power Board

Input Voltage:24V DC nominal 
Output Voltage:+5V DC (±1%)
Current Capacity:10A (50W)
Total Power: 170W maximum
Efficiency: >85% at full load
Ripple Noise: <50mV p-p
Reverse polarity protection
Overvoltage protection (35V DC max)
Inrush current limiting

3300 XL 8 mm Proximity Probes

Unthreaded Length Option : 00 = 0 mm
Overall Case Length Option : 02 = 20mm
Total Length Option : 10 = 1.0 metre (3.3 feet)
Connector and Cable-Type Option : 02 = Miniature coaxial ClickLocTM connector, standard cable
Agency Approval Option : 00 = Not required
Probe Tip Material: Polyphenylene sulfide (PPS).
Probe Case Material: AISI 303 or 304 stainless steel (SST)

IM151-8F PN/DP Interface Processor

POWER SUPPLY MODULE

POWER SUPPLY MODULE
30 AMP
24 VDC
100 WATT