
Symphony Plus Controller
Processor:Dual-core ARM Cortex
Memory:2GB RAM
I/O Capacity:Supports up to 512 I/O points
Power Supply:24V DC
Power Consumption:≤15W (typical)
Ethernet: 2× 10/100/1000 Mbps
Fieldbus: PROFIBUS DP, Modbus TCP/RTU
Positioning Module
SIMATIC DP
Electronics module for ET 200S
1 SSI 25 bit/1 MHz 15 mm width
Module for connection of
absolute value encoders
with SSI Synchronous SerialInterface
with DI and comparison value
with clock synchronization
3300 5mm Proximity Probes
330173 3300 5mm Probe
M8 x 1 thread,without armor
Minimum unthreaded length: 0 0 = 0.0mm
Minimum unthreaded length: 0 3 = 30mm
1 0 1.0 metre (3.3 feet)
0 2Miniature coaxial ClickLocconnector
standard cable
0 0 Agency Approval Option
3300 XL 25 mm Proximity Probe
05 1 ½ - 12 thread
MinimumUnthreadedLength0 mm
MinimumUnthreadedLength 40 mm
50 5.0 metres (16.4 feet)
01 with SST Armor
05 Multiple Approvals
Thrust Transmitter
25 25-0-25 mils
70 7.0 meters (23.0 feet)
01 35 mm DIN-rail clips
05CSA Division 2, ATEX Zone 0
ATEXZone 2 and includes
ABSmaritime approval
ESB Bus Coupler Module
EC402 ESB Bus Coupler Module
5 Standard type with no explosion protection
E Standard type with explosion protection
0 Basic type
1 With ISA Standard G3 option
Operating Voltage:24 V DC
Operating Temperature:-40°C to +85°C (-40°F to +185°F)
Humidity:5–95% RH (non-condensing)
990 Vibration Transmitter
05 0-5 mils pp (0-125 μm pp)
71 7.0 meters (23.0 feet)
01 35 mm DIN rail clips
05CSA Division 2, ATEX Zone 0
ATEXZone 2 and includes
ABSmaritime approval
CPU Module
SIMATIC S7-200 SMART
CPU SR60, CPU, AC/DC/relay
onboardI/O: 36 DI 24 V DC
24 DO relay 2A; Power supply
AC 85-264 V ACat 47-63 Hz,
Program/data memory 50 KB
Thermocouple Heat Sensor Cable
Thermocouple Type:Type J, K, T, or other
Voltage Rating:300V AC/DC (typical)
Conductor Gauge:20 AWG to 24 AWG
Jacket Material:High-temp PVC
DRIVE BOARD
DRIVE BOARD
SBR2
MEASURING TRANSDUCER
FOR RESOLVERS WITH PULSE ENCODER
SPARE PART
SIMOVERT MASTERDRIVES
PowerFlex 753 AC Packaged Drive
PowerFlex 753 AC Drive, with Embedded I/O
Standard Protection, Forced Air, AC Input with DC Terminals
Open Type, 22 Amps, 11kW ND, 7.5kW HD
400 VAC, 3 PH, Frame 2, Filtered
CM jumper installed (preferred)
DB Transistor, Blank (No HIM)
POWER DRIVE BOARD
Input Voltage:24V DC (±10%)
Gate Drive Output:+15V / -8V (IGBT control)
Isolation Voltage:2500V AC (gate-to-control)
Switching Speed:<100ns (turn-on/off)
Current Sensing:±0.5% accuracy
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.