Bently Nevada

3300 XL 11 mm Extension Cable

080 8.0 meters (26.2 feet)
01 Armored cable
05 Multiple Approvals
Outputresistance50 Ω

3300 XL 8 mm Proximity

Tip Diameter: 8 mm
Cable Length: 130 inches (10.8 feet)
Measurement Range: Up to 2 mm (80 mils)
Linear Range: 0.25–2.0 mm (10–80 mils)
Output Sensitivity: -7.87 V/mm (-200 mV/mil)
Frequency Response: 0–10 kHz

16710 Interconnect Cables

3-conductor shielded 
22 AWG (0.5 mm2) 
armored cable with 3- socket plug at one end, 
terminal lugs at the other end
Minimum length of 3.0 ft (0.9 m),
 maximum length of 99 ft (30 m).
Cable Length Option in feet : 35 = 35ft

3300 5mm Proximity Probes

330171 3300 5mm Probe
1/4-28 UNFthread, without armor
0 0 = 0.0 in.
Minimum unthreaded length: 20 = 2.0 in
0 5 0.5 meter (1.6 feet)
0 2Miniature coaxial ClickLocconnector
standard cable
0 0 Agency Approval Option

990 Vibration Transmitter

05 0-5 mils pp (0-125 μm pp)
50 5.0 meters (16.4 feet)
70 7.0 meters (23.0 feet)
01 35 mm DIN rail clips
05CSA Division 2, ATEX Zone 0
ATEXZone 2 and includes 
ABSmaritime approval

3300 NSv Extension Cable

3300 NSv Extension Cable
060 6.0 meters (19.7 feet)
06 FluidLoc cable without stainlesssteel armor
Extension cabledc resistance
Center conductor: 0.220Ω/m (0.067 Ω/ft)
Shield: 0.066 Ω/m (0.020Ω/ft)

3300 NSv Proximity Probes

330905  3300 NSv Probe
M10X1 thread,without armor
Minimum unthreaded length:80 mm
Minimum length: 130 mm
10 1.0 meter (39 in)
12 Miniature coaxial ClickLoc connector
FluidLoc cable

3300 NSv Extension Cable

060 6.0 meters (19.7 feet)
04With stainless steel armor
withFEP jacket
with connectorprotector
05 Multiple Approvals

Interconnect Cable

Impedance: Probable 50 Ohms
Voltage Rating: ≤30 V DC
Operating Temperature: -40°C to +85°C 
Shielding: Dual-layer (foil + braided shield) for robust EMI/RFI protection
Bend Radius: ≥10x cable diameter

3300 XL Standard Extension Cable

065 6.5 meters (21.3 feet)
01 With stainless steel armor, withFEP jacket
00 Not Required

Case ExpansionTransducer Systems

Input Power:+24 Vdc, 30 mA minimum
Input Power:+13.5 to +26 Vdcunregulated
30 mAminimum
Voltage:+1 to +6 Vdc, all models
Output Noise:<10 mV
135613-01 and -11 0.20 V/mm (5.0 V/in)

3300 XL 11 mm Extension Cable

3300 XL 11 mm Extension Cable 
080 8.0 meters (26.2 feet) 
11 Armored FluidLoc cable
05 Multiple Approvals

Emergency Shutdown Device

Ethernet-6 Ports:10/100 Mbps
Protocol :TCP/IP
Input Range:18-36 Vdc Voltage
Power Consumption:24 W Typical/35 W Maximum
Closed StateImpedance:57 KΩ Maximum
Open StateImpedance:187 KΩ Minimum
Internal WettingVoltage:10-15 Vdc
Input Resistance:150 KΩ Typical
Faulted InputTolerance:±40 V

Vibration Monitors

DC Input :18~36 Vdc, max 7.5 W
Scale Factorrange:5 to 1000 mV/g
Full scale range: 2 to 80 g peak
Current SinkSource:3.3 mA ± 5%
Open CircuitVoltage:-21 to -24 Vdc
ConfigurableBandpass filter:0.2 Hz to 20 kHz
Supply Voltage :-22.8 to –25.2 Vdc
Maximum RatedCurrent:15 mA

330103 3300 XL 8 mm Probe

330103 3300 XL 8 mm Probe
M10 x 1 thread,without armor
Example: 0 6 = 60 mm
Maximum case length: 250 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required

Rack Interface I/O Module

RIM I/O Module with Modem Interface
Voltage: 24V DC (±10%)
Consumption: ≤15W
Analog Inputs:4–20mA
Digital Inputs:24V DC dry contact
RS-485:Modbus RTU @ 115.2kbps max

TRANSDUCER

0 1 ¼-28 UNF integral stud
0 5Multiple approvals (CSA, ATEX, IECEx,)
Sensitivity 2.5 mV/m/s2 (25 mV/g) ±5%.
AmplitudeLinearity ±1% to 735 m/s2 (75 g) peak.
TransverseSensitivity Less than 5% of axial.
Amplitude ofResonantPeak20 dB maximum

Interconnect Cable

Shielding:100% foil/braid shielding
Impedance: 50Ω ±10%
Max Signal Frequency: Up to 20 kHz 
Operating Range: –55°C to +250°C
Flexibility: 500+ flex cycles
Bend Radius: 8x cable diameter 

Control Transformer Module

Input Voltage:120V AC ±10%
Output Voltage:24V DC regulated
Power Rating: 100VA (typical)
Efficiency: >85% at full load
Isolation: 1500V AC input-to-output
Thermal Protection: Shutdown at >85°C 

Dual Differential Expansion Monitor

Sensor Input:-24V DC @ 4mA 
Analog Output:4-20mA
Relay Outputs:3 per channel
Communication:RS-485 Modbus RTU (optional)
Measurement Range:±4mm (±0.16 in) standard
Resolution:0.1% of full scale
Frequency Response:DC to 10Hz (-3dB)
Channels:2 fully independent monitoring channels

Dual Accelerometer Monitor

1 5 0-25 mm/s pk 
1 5 0-25 mm/s pk
val Option0 0 Not required 
0 0 None 
Measures Absolute Machine Housing
Provides Two Independent Channels
Provides Over 10,000 High-Pass and Low-Pass Filter Combinations

Dual Vibration XY/GAP Monitor

1 5 0-500 µm pp
0 1 3300 8 mm, 3300 XL 8mm 
or7200 5 mm and 8 mm
0 3 7200 11 mm Proximitor®Sensor(not XL), 100 mV/mil 
0 0 No Relays 
0 0 Not required
0 2 Internal 

Proximitor Seismic Monitor

Signal Accepts from:1 to 4 proximity
velocity or accelerationtransducer signals
Power consumption:7.7 watts, typical
Standard:I/O 10 kΩ
Output Impedance:550 Ω
Transducer Power Supply:-24 Vdc
Voltage Compliance:0 to +12 Vdc range acrossload

3300 XL 11 mm Probe

330707 3300 XL 11 mm Probe
5/8-18 UNFthread, without armor
Example: 2 40 = 2.0 in
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required

3300 XL Proximitor Sensor

3300 XL Proximitor Sensor
11 1.0 meter (3.3 feet) system length
51 5.0 meters (16.4 feet) system length
91 9.0 meters (29.5 feet) system length
05 CSA, ATEX, IECEx  Approvals