
MODULE CARRIER
MODULE CARRIER
POWER SUPPLY CARRIER
USE WITH 8718-CA-NS OR 8715-CA-BI
WITH DC POWER FEED
DIN RAIL OR PANEL MOUINT
PAC8000 I/O is a completely modular I/O solution
REMOTE I/O NODE CONTROLLER
Network Protocol:Ovation High-Speed Bus (HSB)
Data Rate:100 Mbps (Full Duplex)
Node Capacity:Up to 64 I/O modules
Maximum Distance:2 km
Processor:32-bit RISC @ 400MHz
Memory:128MB SDRAM, 64MB Flash
Scan Time:10ms (typical for 64 modules)
I/O Capacity:2048 points (mixed I/O)
Analog Input Module
SPARE PART
INPUT MODULE
PMOD ASSEMBLY
ANALOG INPUT
8 CHANNEL
VOLTGAGE W/ TEMPERATURE SENSOR
Fieldbus H1 Card
FIELDBUS H1
SERIES 2
POWER RATING / 300MA / 12VDC
FIELDBUS POWER / 12MA/PORT / 9-32VDC
-40-70DEGREE C
DELTAV KJ3242X1-BA1 FIELDBUS
12P2471X052
SISNet Terminator Assembly
1-wide SISNet Terminator Assembly
(right-hand extender card and two termination resistors)
KJ4001X1-NA1 Horizontal LocalBus Dual Right Cable Extender
KJ4001X1-NB1 Horizontal LocalBus Dual Left Cable Extender
S-Series DO 32-Channel 24 VDCHigh-Side Card
Local Bus Power :12 VDC at 150 mA
Bussed Field Power:24 VDC at 3.2 A/Card
Field Circuit:24 VDC at 100 mA/Channel
Ambient Temperature:-40°C to +70°C
Shock:10g ½ Sinewave for 11msec
Vibration:1mm Peak to Peak from 2 to 13.2Hz;
0.7g from 13.2 to 150Hz
1-Wide I/O Carrier ExtenderRight
VS6051
CABLE EXTENDER
DUAL RIGHT EXTENDER
8 AMP
12.6 VDC
LOCALBUS
Horizontal LocalBus Dual Right Cable Extender
Discrete Input Card
S-Series DI 32-Channel 24 VDC
Dry Contact Card
Input Voltage Range:5–60V DC (24V DC nominal)
On-State Threshold:≤ 5V DC (logic "1")
Off-State Threshold:≥ 15V DC (logic "0")
Input Impedance:3.3 kΩ (typical)
Input Current:≤ 8 mA @ 24V DC (per channel)
Max Continuous Voltage:60V DC
Isolation:Group-to-Group: 300V AC RMS
Analog Input Module
Channels: 8
Signal Type: 4–20 mA DC
nput Range:4–20 mA DC (configurable for 0–20 mA)
Overrange Capability: -1 mA to +25 mA
Input Impedance:≤ 250 Ω (typical)
Accuracy:±0.05% of span (at 25°C)
Temperature Drift:±0.005% of span/°C (-40°C to +70°C)
Resolution:24-bit
AO 8-Channel 4-20 mA HART Card
AO 8-CHANNEL 4-20MA HART CARD
12P4704X032
Channels: 8
Signal Type: 4–20 mA DC
Output Range:4–20 mA DC
Load Resistance:300–1100 Ω
Accuracy:±0.1% of span (25°C)
Temperature Drift:±0.02% of span/°C (-40°C to +70°C)
Resolution:15 bits (including sign)
Redundant AI 8-Channel TerminalBlock
Signal Type: 4–20 mA DC
Standard: 4–20 mA DC
Overrange: -5 mA to +25 mA
Input Impedance: ≤ 250 Ω (typical)
Field Power 30 VDC at 200 mA
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
8-Channel Terminal Block
TERMINAL BLOCK REDUNDANT INTERFACE
Field Power 30 VDC at 100 mA
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
DIGITAL INPUT MODULE
DIGITAL INPUT MODULE
NAMUR CARD
8-CHANNEL
LOCALBUS POWER 12 VDC AT 150 MA
(12P4692X042)
CIRCUIT BOARD CARD
I / O BOARD
DIGITAL BUFFER
CARD CAGE
Analog Inputs: 8–16 channels
Digital I/O: 16–32 channels
Single Acting Reverse Relay
Actuator Compatibility:spring-return actuators
Supply Pressure Range: 3–30 psi
Input Signal: 4–20 mA
Port Sizes: 1/4" NPT or G1/4 threaded ports
Temperature Range: -40°C to +85°C (-40°F to +185°F)
PNEUMATIC RELAY
38B5786X132
PNEUMATIC RELAY
FIELDVUE DVC6000
STANDARD BLEED
SINGLE ACTING
DIRECT
Analog Output Module
S-Series AO 4-20 mA HART 8-Channel
Local Bus Power 12 VDC at 150 mA
Bussed Field Power 24 VDC at 300 mA
Field Circuit24 VDC at 23 mA/Channel
Ambient Temperature -40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3
Analog Output Module
S-Series AO 4-20 mA HART 8-Channel
Local Bus Power 12 VDC at 150 mA
Bussed Field Power 24 VDC at 300 mA
Field Circuit24 VDC at 23 mA/Channel
Ambient Temperature -40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.