
3300 XL 8 mm Probe
3300 XL 8 mm Probe
M10 x 1 thread,without armor
10 1.0 meter (3.3 feet)
11Miniature coaxial ClickLocconnector with connectorprotector
FluidLoc cable
00 Not required
3300 XL 8 mm Probe
3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
Enhanced Logic Manager Module
Input Voltage:Typically 24 VDC
Power Consumption:Around 25 W
Operating Temperature Range:Typically -20°C to 60°C
Storage Temperature Range:-40°C to 85°C.
Relative Humidity:5% to 95% non-condensing.
Input Terminal Board
Series: Mark VI
Model Number: IS200AEADH4ADA
Type: Input Terminal Board
Input Voltage:
Typically operates at 24V DC
Operating Temperature Range:
-40°C to +85°C (-40°F to +185°F)
CIRCUIT BOARD
Input Voltage:
Typically operates at 24V DC
Operating Temperature Range:
-40°C to +85°C (-40°F to +185°F)
Serial Communication: RS-232/RS-485
Printed circuit board
Input Voltage: Typically 24 V DC
Operating Temperature Range:
Typically -30°C to +70°C (-22°F to 158°F)
Storage Temperature Range:
-40°C to +85°C (-40°F to 185°F)
Safety-Related Controller
Compact controller
with 24 digital inputs
8digital outputs
2 counters and 8 analog inputs
operating temperature -20...+60 °C
for SILworXprogramming tool
Quad Processor Pack
Two -synchronous- processors
Flash memory for system and applicationprogram
RAM with battery backup (battery located inBKM-0001)
Data comparators for the processors and theirmemory
Minimum and maximum execution timemonitor
Memory error handler
1oo2D functionality
24V and 5V monitoring
Emergency Shut Down Input (24V)
Two outputs (for non-redundant resp.redundant IO)
Signal conditioner
Voltage at min. GAP:−1.6 V
Voltage at max. GAP:−17.6 V
Dynamic range:16 V
Output impedance:500 Ω
Short-circuit current:45 mA
Voltage:−20 to −32 V*
Current:−13 mA ±1 mA (−25 mA max.)
Optical ESB Bus Repeater Module
Type: Optical ESB Bus Repeater Module
Bus System: ESB
Connector Type: SC or LC connectors
Operating Voltage: Typically 24 V DC
Operating Temperature Range: -10°C to 60°C (14°F to 140°F)
Power Consumption: Typically low, around 3-5W
Single Board Computer
Processor:Typically powered by a PowerPC 7448
Memory:512 MB to 2 GB DDR2 RAM
CompactFlash or Solid-State Drive (SSD)
Bus Speed: 40 MHz
Voltage: Typically 5V DC
Power Consumption: 20-50W
Operating Temperature: Typically 0°C to 70°C (-40°C to +85°C)
Storage Temperature: Typically -40°C to +85°C.
Humidity: 5% to 95% relative humidity
Point I/O module
Series:POINT I/O
Module Type:Serial Interface Module
Key Switch Position:2
Voltage Range:10-28.8 volts DC
Supply Voltage:24 volts DC nominal
Supply Current:15mA at 24 volts DC
MBUS+ PROG BRIDGE
Communication port protocol:Modbus Plus
Communication port support:RS232
Modbus Plus bridges and repeaters
characteristics:Programmable
Bridge
Mounting support:Panel Enclosure
Number of port:4
Rated supply voltage:115...220 V AC 24 V DC
SSI Module
Product Description:Serial Synchronous Interface (SSI) module
SSI Channels:1
Product Family:1734 POINT I/O
Supply Voltage:10-28.8 Volts DC
Part Number:1734-SSI
POINTBus Current:110 milliamps
Power Dissipation:0.94 Watts
No of SSI channels:One (1) SSI port
Supply current :110mA @ 24V dc
Operating Temperature:-20 to 55oC (-4 to 131oF)
Storage Temperature:-40 to 85°C (-40 to 185°F)
ACTUATOR
MODUTROL IV MOTOR
NON-SPRING RETURN
FOOT MOUNTED
4-20 MA MODULATING CONTROL SIGNAL
160 DEGREE STROKE
15-30 SECONDS TIMING
8.5 NM / 75 LB-IN TORQUE RATING
15 VA
120 VAC
50/60 HZ
INVERTER POWER BOARD
INVERTER POWER BOARD
LOW VOLTAGE CONVERTER
INPUT: 0.7 AMP 320-1244 VDC
OUTPUT: 3 AMP 32 VDC 180 W
IP00
3300 XL NSv Proximity
3300 NSv Probe
M8X1 thread, witharmor
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals
8mm Eddy Current Sensor
Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)
mm Eddy Current Sensor
Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)
TELEPERM XP FUM 210 MODULE
Part Number: 6DP1210-8AC
System: TELEPERM XP
Input Voltage: 24 V DC
Power Consumption: 15 W
Operating Temperature: -5°C to 45°C
Driver board
Input Voltage Range: Typically 24V DC
Output Voltage Range: Dependent on the connected load
Current Rating: Up to 10A
Power Rating: Typically around 240W
Operating Frequency: 1kHz to 20kHz
Expansion Module Safety Relay
440REM4R2
EXPANSION MODULE
GUARDMASTER
GSR EM
MONITORING SAFETY RELAY
1 SINGLE WIRE SAFE INPUT
1 NC SOLID STATE AUX OUTPUT
24 VDC SUPPLY
SAFETY RELAY
440RS12R2
SAFETY RELAY
GUARDMASTER
SINGLE INPUT
1 DUAL CHANNEL UNIVERSAL INPUT
1 N.C. SOLID STATE AUXILIARY OUTPUTS
24 VDC 2.5 W SUPPLY
AC15 250V / 1.5 AMP
DC13 24V / 2 AMP OUTPUT
REPLACES 440R-J23106
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.