
3300 NSv Extension Cable
3300 NSv Extension Cable
065 6.5 meters (21.3 feet)
00 Without stainless steel armor
00 Not Required
Interconnect Cable
Conductors:2 twisted pairs
Wire Gauge:24 AWG stranded copper
Shielding:Individual foil + overall braid
Impedance:100 Ω ±10%
Capacitance:≤30 pF/ft
Max Voltage:300 V AC/DC
Resistance:≤25 Ω/1000 ft
3300 NSv Proximity Probes
330904 3300 NSv Probe
M8X1 thread, witharmor
Minimum unthreaded length:20 mm
Minimum length: 140 mm
05 0.5 meter (20 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals
Bently Nevada Proximitor Probe Extension Cable
Product no : 21747-045-01
Product type : Proximitor Probe Extension Cable
Cable length option : 045 = 4.5 metre (177 inches)
Armor option : 01 = with armor
Velomitor Piezo-velocity Sensor
04 1/4 - 20 UNC
00 Not required
Sensitivity:3.94mV/mm/s (100 mV/in/s)±5%.
Velocity Range:1270 mm/s (50 in/s) peak
Output BiasVoltage:-12 ±3.0 VDC
DynamicOutputImpedance :Less than 2400 Ω
OperatingTemperatureRange:-55°C to 121°C(-67°F to 250°F)
Drive Unit Drive Controller
Control Platform:32-bit RISC processor with FPGA logic
Control Methods:DTC , Scalar, Vector
I/O Capacity:16x DI
Operating Voltage:24 V DC (±10%)
Power Consumption:25 W (typical)
Memory:2 GB Flash (firmware/logs)
Controller Module
Model: KUC755AE117 / 3BHB005243R0117
Product Type: Controller Module
Power Supply Voltage: 24V DC
Operating Temperature: 0°C to +55°C
Storage Temperature: -20°C to +70°C
Humidity: Relative humidity 5% -95%
3300 XL 8 mm Probe
3300 XL 8 mm Probe
3/8-24 UNFthread
without armor
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx Approvals
Velomitor Piezo-velocity Sensor
01 1/2 - 20 UNF
00 Not required
Sensitivity3.94mV/mm/s (100 mV/in/s)±5%
Velocity Range 1270 mm/s (50 in/s) peak
Output BiasVoltage-12 ±3.0 VDC
overtemperature referenced toPin A
High voltage inverter board
Rated System Voltage:3300V AC (2.3–4.16 kV range)
DC Link Voltage:5600V DC (max)
IGCT Control :24x Gate driver channels
Gate Drive Voltage:+20V / -5V
Auxiliary Power:24V DC (±10%), 150W
Isolation Voltage:6 kV AC
Response Time:<2 µs
3300 XL 8 mm Proximity Probe
3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
Power Supply Module
Product Type : Power Supply Module
Model : SPW481 =
100-120V AC Input Power Supply Module
Standard type with no explosion protection
With ISA Standard G3 and temperature (-20C - 70C)
Analog Input Module
Input Channels :16 Channels
A/D Converter Resolution:16 bits
Input Range:1 4-20 mA only (through 200 Ω)
Normal Mode Rejection Ratio, at 60 Hz:19 dB
Maximum Normal Mode Input: ± 30 Volts
Crosstalk, dc to 60 Hz (channel-to-channel):-60 dB
Input Scan Rate:50 ms
Analog Output Module
Power supply:24V DC
Rated Current:55mA at 24V
Power Consumption:1.32W at 20mA
Power/DCS to Field:1500 VAC
DCS side connections:
37 pin DSUB connector on CC-UGIA01
Voltage Input:24V DC
Interface to DCS:4 to 20mA with HART
Extension Cable
PROBE PROXIMITY SENSOR
CABLE EXTENSION 121FT
Impedance/Capacitance:±200 mV/mil typical
Extreme temperatures:+200°C/+392°F
Maximum Cumulative Length: typically 1,000–2,000 ft
3300 XL Standard Extension Cable
085 8.5 meters (27.9 feet)
12 FluidLoc cable with connectorprotector
05 CSA, ATEX, IECEx Approvals
3300 XL Standard Extension Cable
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.