
Transmitter Controller
Function:8-channel analog input (4-20mA)
Input Channels:8 (isolated)
Signal Range:4-20mA
Input Impedance:250 Ω
Accuracy:±0.1% FS (at 25°C)
HART Support:FSK modulation (1200/2200Hz) via same wires
Power Supply:24 V DC loop power
Isolation :500 V AC
Transmitter Controller
Functions:4x 4-20mA Input
Signal Range :4-20mA
Accuracy:±0.05% FS (23°C)
Loop Power:24 V DC
Isolation:500 V AC (channel-to-bus)
Max Devices:16 per segment
Power:9–32 V DC
Control Board
Hardware Generation:G4 (4th Gen)
Status:Discontinued (since ~2003)
Replacement:AC 800M Controller Series
Memory:4 MB DRAM + 2 MB Flash
Backup Battery:3.6 V Li (BR2325) for RAM retention
Cycle Time:≤100 ms
I/O Capacity:Up to 1024 I/O points
Supply Voltage:24 V DC ±10%
Power Consumption:15 W (max)
Control Board
Memory:2 MB SRAM
Profibus DP Ports:2x RS-485
Baud Rate:9.6 kbps – 12 Mbps
Max Devices:124 slaves per segment
Supply Voltage:5 V DC ±5% (via backplane)
Power Consumption:8 W max
Isolation:500 V AC (field-to-logic)
3300 NSv Proximity Probes
05 0.5 meter (20 in)
02 Miniature coaxial ClickLoc connector
standard cable
00 Not required
I/O Link Cable
Conductors:24V DC
Voltage Rating: ≤30V DC
Current Rating: Up to 2A
Type: M8 or M12 4-/5-pin connectors
Temperature Range: -25°C to +70°C
Digital Output Module
Output Channels 32
Output Type Source
Load Voltage 15 30 VDC Maximum
On-State Voltage 24 V (typ), load current @ 0.5A
Off-State Leak Current 5.0 µA (max)
Turn-On/Turn-Off Time 10 ms (max)
32 Point Digital Input Module
Inputs per module:32 (sinking)
Input Voltage Range:10 VDC to 32 VDC
Peak Voltage:32 VDC
AC Frequency: N/A
ON Voltage Level:9.5 VDC minimum
OFF Voltage Level:3.5 VDC maximum
Input Impedance:6.9 K ohms nominal
Minimum ON Current:1.0 mA
Maximum OFF Current:0.7 mA
High Speed Ethernet Switch
Ports 5 Ethernet ports
(RJ45 connectors)
Port Speed 10/100/1000 Mbps
Switching Capacity 10 Gbps
Input Voltage 12-48 VDC
Power Consumption <5 W
Operating Temperature Range -40°C to +75°C
Storage Temperature Range -40°C to +85°C
Humidity 5% to 95% non-condensing
Mounting Options DIN rail or wall-mountable
Power Distribution Cable
POWER DISTIBUTION CABLE
TRANSFERS POWER
FROM MB-0001 TO PDB-0824
24 VDC
145 CM LENGTH
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.