ALL MANUFACTURERS

Power board

voltage measurement 
CM C98043-A7117-L1
Input Power AC:3‑phase (50‑60 Hz)
DClink Output:400‒610 VDC
Max SCR trigger freq:5kHz
Ambient working:-25°C-+ 55°C

PLC BOARD

PLC BOARD
T400 BD W/ WINDER SOFTWARE
PRELOADED
ENGLISH/GERMAN
SIMADYN D T400 

Firing pulse transformer

Firing pulse transformer 
up to 1000 A DCM
Primary Voltage Range:5–15V DC Pulse
Secondary Output Voltage:20Vpk
Trigger Current Transfer:≥150mA gate trigger output
Signal Rise Time:<0.1μs (typical)
Isolation Voltage:≥4kV AC RMS

Technology module

SIMADYN D 
Technology module 
T400 for 6SE70/71 and SRT400 32 Bit/32MHz
8BE, 2BA, 4BE/BA 5AE, 2 AO
2 pulse encoder inputs 2SER
INTERFACE+1SSI-encoder or 1SER
INTERFACE+2SSI-encoder Configurable 
with D7-SYS 1MB Flash, 2MB RAM
32KB EEPROM

DC Speed Control Power Supply Board

Input Voltage:110–230 V AC
Rated Power:Max ~10 W total load
DC Outputs:±15V (±1%) 
Control Loop:+24V DC (±5%) 
Max Current:+15V: 700 mA†
Voltage Ripple:50 mVpp (20 MHz BW)
Frequency Stability: 50/60 Hz (±3%)

CONTROL BOARD

CONTROL BOARD
CPU BOARD
Supply Voltage: 24 V DC (±15%)
Supply Voltage: 24 V DC (±15%)
Signal Inputs: 16 mA
Signal Outputs: 250 mA
Embedded Processor: 150 MHz

ELECTRONIC CONTROL BOARD

ELECTRONIC CONTROL BOARD
ADVANCED
DC SPEED
Control electronics 
Advanced painted 
incl. terminals 32 MB 
C98043-A7100-L204

Electronic module

INPUT MODULE
ET200L
32 POINT
DIGITAL
24 VDC

3300 NSv Proximity Probes

330908 3300 NSv Probe
3/8-24 UNF thread,without armor
Minimum unthreaded length: 3.9 in
Minimum case length: 7.1 in
05 0.5 meter (20 in)
01Miniature coaxial ClickLoc 
connectorwith connector protector, standardcable
00 Not required

Accelerometers

01 ¼-28 to M6 x 1.00 Stainless Steel
00 100 mV/g ± 20% (10.2 mV/m/s^2±20%)
00 No Approvals
Mounting Thread 1/4-28 Female
Mounting Torque(Maximum)2 to 5 ft-lb
Sensing Element Ceramic
Sensing Geometry Shear
Housing Material Stainless Steel
Sealing Welded Hermetic
Electrical Connector 2-Pin Mil-C-5015

3300 XL 8 mm Proximity Probes

330101 3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
Minimum unthreaded length: 1.0 in
Maximum case length: 2.7 in
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required

3300 XL 8 mm Reverse Mount Probes

330105-02-12-CC-DD-EE3/8-24 UNF threads
05 0.5 meter (1.6 feet)
02 Miniature ClickLoc coaxialconnector

3300 XL 8 mm Proximity Probes

330101 3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
Maximum case length: 2.4 in
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx  Approvals

3300 NSv Proximity Probes

330905 3300 NSv Probe
M10X1 thread,without armor
Minimum length: 18 mm
05 0.5 meter (20 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals

Digital Input Module

Type: Digital Input Module
Channels: 40 isolated input channels
Input Voltage: Nominal 24 VDC (range: 18–32 VDC)
Input Current: 6 mA per channel typical
Input Impedance: Approx. 4 kΩ
Logic Thresholds:
Logic '1': ≥15 V
Logic '0': ≤5 V

Trusted I/O and Communication Module

SHIELD FOR I/O AND 
COMMUNICATION MODULE 1SLOT
Trusted Shield Single Slot Width
Input Voltage:24V DC
Power Consumption: 8W 
Digital Inputs: 16–32 channels

Remote Expansion Cable

Full Trusted Controller Capability
100-240 Vac Input
Portable wheeled flight case
Simulation of 60 Field Signals
Pre-wired Dual Ethernet (point to point and hub)
Serial Comms wired to terminals
Configured for Companion Slot DI, AI and DO Modules

Trusted I/O SmartSlot Cable

Model Number: TC-501-02-6M5
Type: I/O SmartSlot Cable
Configuration: Typically used for internal connections
Channels: Supports 40 channels
Termination: Connects Trusted® I/O modules 
to FTAs or VFTAs

Panel Mount Operator Advisor Panel (OPADP)

Communication Protocol:Modbus RTU over RS‑485
Display:128 × 64 pixel LCD
Keypad:5-button navigation
LED Status Bar:Yes (visual feedback)
Power Supply:24 V DC
Operating Temp:–20 °C to +70 °C
Storage Temp:–40 °C to +85 °C
Humidity:0–95 % RH, non-condensing

Digital Input 24V IOTA Redundant

Galvanic isolation
Open wire detectio
Optional redundancy
Direct / Reverse Input Indication
Supplies Non-incendive field power
Internal or external field power selection
Extensive internal diagnostics for data integrity

HART Analog Output Module

Input Voltage:100–240 VAC (universal) 
Output Voltage:24 VDC (adjustable up to ~27 V)
Output Current:20 A continuous
Protections:Overcurrent, overvoltage, short-circuit
Operating Temperature Range:–25 °C to +70 °C

Safety Manager System Module

Supply voltage: 24 V DC
Reset input voltage: 18 - 70 V DC
Reset input current: 1.1 mA at 24 V DC
Earth fault threshold: 5.5 mA (± 1 mA)
Max. earth current: 25 - 32 mA

Electronic Earth Leakage Detector

Supply voltage: 24 V DC
Reset input voltage: 18 - 70 V DC
Reset input current: 1.1 mA at 24 V DC
Earth fault threshold: 5.5 mA (± 1 mA)
Max. earth current: 25 - 32 mA
Max. output current: 2 A
Isolation 1500 V DC / 1000 V AC
Initial contact resistance: 30 mW
Operating temperature: -5°C-+50°C (23°F-+122°F)
Max. output voltage: 36 V DC / 30 V AC

DESK OPERATOR ENTRY PANEL

Power Supply:12–24 V DC 
Current Consumption:250 mA @ 24 V DC
Connectivity:Serial (RS‑232);
Mounting:Desk or panel mount with screw terminals
Enclosure Type:Indoor use; IP20 equivalent
Operating Temp:0 °C to +50 °C
Storage Temp:–40 °C to +85 °C
Humidity Limits:Up to 90–95% RH, non-condensing

FTA interconnection cable

Direct connection between two 
FS-CP series process controllers
20meters long
Shielded twisted pair design
Easy to install and use
Hot-pluggable