
























Splitter Board
Input Voltage:24V DC (±10%)
Power Consumption:2W max
Isolation Voltage:1500V AC
Input Channels:4 (configurable)
Output Channels:8 (1:2 splitting ratio)
Signal Types:4-20mA, 0-10V, digital
Exciter Control Module
Power Supply:110/220V AC ±10% or 24/48V DC
Power Consumption:50W (max)
Field Voltage :0-300V DC (adjustable)
Field Current:0-20A DC (continuous)
Control Accuracy:±0.25% of setpoint
Response Time:<10ms
Voltage Regulation:±0.5% of nominal
Frequency Range:40-70 Hz
Stability:<0.1% oscillation
Harmonic Distortion:<1% THD
Processor Unit Relay Card
Operating Voltage: 24V DC
Power Consumption: ≤5W
Isolation: 2.5kV AC
Processor: 32-bit DSP
Memory:64MB Flash
Mounting Equipment, 130mm
Mounting kit for SIPART PS2
Schwenkantriebe nachVDI/VDE 3845 (Namur)
Kupplungsrad aus Kunsttoff
Mounting Equipment, 130mm
Aluminum Electrolytic Capacitors
1500 µF 350 V
Aluminum Electrolytic Capacitors Radial,
Can - Screw Terminals 47mOhm @ 100Hz
12000 Hrs @ 85°C
LAN Communications Card
TURBINE CONTROL SYSTEM
MARK V
SPEEDTRONICS
W/FIRMWARE
16 DIGIT DISPLAY
Discrete Output Pack
Input Voltage:24V DC (±10%)
Power Consumption:5W (max)
Output Channels:16 channels (sourcing)
Output Type:Solid-state (MOSFET)
Load Voltage:12-48V DC
Current per Channel:0.5A continuous (2A peak)
Isolation:1500V AC
OEI-BOARD
Power Supply:24V DC (-15%/+20%)
Power Consumption:6W typical
Optical Interfaces:2× 100BASE-FX (1300nm)
Electrical Interface:1× 10/100BASE-TX
Isolation:1500V AC
Data Rate:100Mbps full-duplex
Thyristor Modules
POWER BLOCK MODULE
1400V 410A DUAL
641-TT210N14KOF
Infineon Technologies
Gate Trigger Current - Igt:200 mA
Holding Current Ih Max:300 mA
Output Current:410 A
AC DRIVE ADJUSTABLE FREQUENCY
AC DRIVE
ADJUSTABLE FREQUENCY
POWERFLEX 70
480 VAC
3 PHASE
1.1 AMP
0.37 KW
0.5 HP
PANEL MOUNT
INTERFACE MODULE - FULL NUMERIC LCD
MANUAL
WITH BRAKE
Torque-RPM Adapter
Model Number:1-G070A-2
Type:Torque-RPM Signal Conditioner
Application:Motor Drive Systems
Compatibility:Reliance Electric DCS/DC Drives
Power Requirement:120V AC ±10%, 50/60Hz
Power Consumption:15VA max
Isolation:1500V AC (input-to-output)
Control board
Processor:32-bit DSP
Memory:2MB Flash, 512KB SRAM
Control Algorithms:PID with adaptive tuning
Sampling Rate:10kHz
Analog Inputs:8 channels
Digital I/O:24 channels
Encoder Interface:Differential RS-422
Communication Gateway
MLink Hardware Version 2
Internal: Modbus TCP
Fieldbus: Profibus
Modbus RTU/TCP, PROFINET IO
Analog Input Module
SPARE PART
INPUT MODULE
PMOD ASSEMBLY
ANALOG INPUT
8 CHANNEL
VOLTGAGE W/ TEMPERATURE SENSOR
PROXPAC XL Proximity Transducer
2 8 3300 XL 8 mm probe with MultipleApprovals
1 5 1.5 in (38 mm)
0 3 5 3.5 in (96 mm)
0 0No fittings; two plugs and twowashers
0 2 3/4-14 NPT
(Required if orderingStandoff Adapter Option.)
3300 NSv Proximity Probes
330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 0.0 in
Minimum case length: 1.9 in
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cabe
00 Not required
3300 XL 8 mm Proximity Probes
330103 3300 XL 8 mm Probe
M10 x 1 thread,without armor
Minimum unthreaded length: 0 mm
Minimum case length: 160 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.