330103 3300 XL 8 mm Probe
M10 x 1 thread,without armor
Minimum unthreaded length: 0 mm
Minimum case length: 50 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
330101 3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
Minimum unthreaded length: 0.0 in
Minimum case length: 2.3 in
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
PROGRAMMABLE CONTROLLER MODULE
CONTROLLOGIX 5580
3 MB USER MEMORY
2 GB SD CARD MEMORY
100 ETHERNET/IP NODE CAPACITY
1 USB PORT
1 ETHERNET/IP PORT
1200 MA AT 5.1 VDC/5 MA AT 1.2 VDC
0 TO 60 DEGREE C OPERATING TEMPERATURE
SAFETY CONTROLLER
GUARDLOGIX5580
WITH 3MB STANDARD MEMORY & 1.5 MB SAFETY MEMORY
USB PORT
1 GB EMBEDDED ETHERNET PORT
100 ETHERNET/IP DEVICES
4 CHARACTER ALPHA/NUMERIC DISPLAY
Operating Voltage:85–265V AC/DC
Nominal: 120/208V
Maximum: 690V AC
Burden: <0.2VA per phase
Standard CTs: 1A or 5A
Burden: <0.1VA at 5A
Voltage/Current: ±0.2% of reading
Power/Energy: ±0.5%
Frequency: ±0.01Hz
RPC420 Panel Controller for each manual lever
RAM: 512MB (minimum)
Flash Storage: 4GB
2x Ethernet (10/100/1000 Mbps)
4x RS-232/RS-485 (configurable)
1x CAN bus
1x USB 2.0
Input Voltage: 24VDC
Power Consumption: 50W (typical)
Input Channels: Typically 16 channels
Input Signal Type: Dry contact
Low Voltage (TTL): 5–24 V DC
High Voltage: Up to 48 V DC
Input Current: ≤ 5 mA per channel
Power Supply: 10.5–30V DC
Analog: 4–20mA
Digital: PROFIBUS DP/PA
Position Feedback: 4–20mA
Control Accuracy: ±0.5% of span
Supply Pressure: 1.4–7 bar (20–100 psi)
Output Pressure: 0–100% of supply pressure
Air Consumption: < 0.12 Nm³/h
Response Time: < 1 sec
SCALANCE X202-2IRT MANAGED IE IRT SWITCH
2 X 10/100MBIT/S RJ45 PORTS
2 X 100MBIT/S MULTIMODE BFOC
FAULT SIGNAL. CONTACT WITH SET BUTTON
REDUNDANT VOLTAGE SUPPLY
PROFINET IO DEVICE
NETWORK MANAGEMENT
RED. MANAGER INTEGRATED
WITH ELECTRONIC MANUALS ON CD
OPTIONAL C-PLUG
Power Supply Type (Top Slot)
04 Legacy Low Voltage DC (20 to 30 Vdc)
Power Supply Type (Bottom Slot)
04 Legacy Low Voltage DC (20 to 30 Vdc)
114M5330:Low Voltage DC Power Supply
330704 3300 XL 11 mm Probe
M14 x 1.5 thread,with armor
Minimum length:100 mm
10 1.0 meter (3.3 feet)
01Miniature coaxial ClickLocconnector
with connectorprotector, standard cable
05 Multiple Approvals
Impedance:50Ω ±10%
Capacitance:30pF/ft max
Voltage Rating:300V RMS
Shielding:100% coverage
Conductor Gauge:22 AWG
Outer Diameter:6.0mm ±0.2mm
Max signal frequency: 50kHz
Impulse withstand voltage:5 kV (1.2/50 µs)
Rated voltage:600 V
Accuracy:<0.05 % of measuring range
Nominal power consumption:2 VA
Operating altitude:≤ 2000 m
Power consumption:≤2.3 W
Rail:TS 35
Step response time:≤50 µs
Input Voltage:24V DC (±10%)
Power Consumption:15W (typical)
Isolation Voltage:1500V AC
Analog Inputs:±10V
Control Bandwidth:1kHz (typical)
Resolution:16-bit
Update Rate:62.5μs (16kHz)
Nominal On-State Current (ITAV):2000A*
Maximum Surge Current (ITSM):20kA (1ms)
Critical di/dt:500A/μs
Maximum Blocking Voltage (VDRM):1700V
Repetitive Peak Reverse Voltage (VRRM):1700V
Gate Trigger Voltage (VGT):1.5-2.5V
Recommended Switching Frequency:≤500Hz
Nominal On-State Current (ITAV):2500A
Peak Surge Current (ITSM):25kA (1ms)
Critical di/dt:800A/μs
Maximum Blocking Voltage (VDRM):4500V
Repetitive Peak Reverse Voltage (VRRM):4500V
Gate Trigger Voltage (VGT):1.5-2.5V
Repetitive Blocking Voltage:4500V
Non-Repetitive Blocking Voltage (VDSM):4500V
Gate Trigger Voltage (VGT):1.5-2.5V
Average On-State Current (ITAV):3500A
Peak Surge Current (ITSM):30kA (1ms)
Critical di/dt:1000A/μs
Peak Gate Current (IG):50A
Gate Power Dissipation:20W
Blocking Voltage : 4500V Maximum Repetitive Off-State Voltage: 4500V Gate Trigger Voltage (VGT): 1.5-2.5V Average On-State Current : 3500A Turn-On Time (ton): <5μs Turn-Off Time (toff): <10μs Switching Frequency: Up to 500Hz
Blocking Voltage:4500V
Gate Trigger Voltage (VGT): 1.5V to 2.5V
Peak Surge Current (ITSM):30kA
Turn-On Time (ton): <5µs
Turn-Off Time (toff): <10µs
Switching Frequency: Up to 500H
Gate Current (IG): 50A
Series:Mark VI Speedtronic
Functional Acronym:BPPB
Input Voltage: 24V DC
Output Voltages:+5V DC @ 20A max
Efficiency: >90% typical
Ripple: <50mV p-p on all outputs
Multi-Voltage Power Distribution: Provides +5V, ±15V
28 3300 XL 8 mm probe, multiple approvals
05 0.5 m (20 in)
3.5 in (88.9 mm) = 35
3.2 in (81.28 mm) = 032
03 Two plugs, one 3/4-14 NPT fitting
One 3/4-14 to 1/2-14 NPT SST reducer
One cable seal grip with grommets for the
following cable sizes:
1/8 to 3/16 inches
1/4 to 5/16 inches
5/16 to 3/8 inches
02 3/4-14 NPT
330707 3300 XL 11 mm Probe
5/8-18 UNFthread, without armor
Minimum case length: 2.5 in
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
21000 aluminum probe housing assembly
27 3300 XL NSv probe, selectablehazardous area approvals
05 0.5 m (20 in)
Maximum length 4.0 in (101.6 mm)
2.6 in (25.4 mm) = 026
03 One 3/4-14 NPT plug
One 3/4-14 to 1/2-14 NPT reducer
One cable seal grip with grommets for
the following cable sizes:
1/8 to 3/16 inches
1/4 to 5/16 inches
5/16 to 3/8 inches
023/4-14 NPT
27 3300 XL NSv probe, multiple approvals
05 0.5 m (20 in)
No standoff adapter = 00
3.5 in (88.9 mm) = 035
03Two plugs, one 3/4-14 NPT fitting
One 3/4-14 to 1/2-14 NPT SST reducer
One cable seal grip with grommets for the
following cable sizes
• 1/8 to 3/16 inches
• 1/4 to 5/16 inches
• 5/16 to 3/8 inches
02 3/4-14 NPT
Supply Voltage:24V DC
Digital Inputs:24V DC
Analog Inputs:0-10V/4-20mA
Frequency Range: 0Hz - 650Hz
Switching Frequency: 2kHz - 16kHz
Control Response Time: <5ms
Manufacturer: Siemens AG
Main Power: 24-80V DC
Control Voltage: 24V DC (±10%)
Switching Frequency: 16kHz PWM
Power Dissipation: 35W max
Isolation Voltage: 1500V AC
Current Rating:1700A
Voltage Rating:1200V
Gate Trigger Voltage:3V typical
Gate Trigger Current:200mA typical
On-State Voltage Drop:1.6V typical at rated current
Critical Rate of Rise:100A/μs
Isolation Voltage:2500V AC
Control side (logic): +15V / -8V
Auxiliary power: 24V DC
Peak gate current: Up to ±15A
Gate voltage range: +15V
Switching Frequency: Up to 20 kHz
Isolation Voltage: ≥2500V RMS
OUTPUT CARD
FOR MULTI-PARALLEL CIRCUIT
SIMOVERT MASTERDRIVES
Digital Outputs:24V DC
Analog Outputs:0/4-20mA
Supply Voltage: 24V DC
Relay contacts: 250V AC
Transistor outputs: 24V DC
Voltage: ±10V, 12-bit resolution
Current: 0/4-20mA
INTERFACE MODULE
FOR MULTI-PARALLEL CIRCUIT
SIMOVERT MASTERDRIVES
Supply Voltage:24V DC ±10%
Power Consumption:8W (typical)
Isolation Voltage:2500V AC
Data Rate:1Mbps
Fiber Type:50/125μm multimode
Supply Voltage:24V DC ±10%
Power Consumption:15W (max)
Isolation:2500V AC
Response Time:<100μs (fault signals)
Communication Rate:1Mbps (fiber-optic)
Temperature Monitoring:±1°C accuracy
S-Series DI 32-Channel 24 VDC
Dry Contact Card
Input Voltage Range:5–60V DC (24V DC nominal)
On-State Threshold:≤ 5V DC (logic "1")
Off-State Threshold:≥ 15V DC (logic "0")
Input Impedance:3.3 kΩ (typical)
Input Current:≤ 8 mA @ 24V DC (per channel)
Max Continuous Voltage:60V DC
Isolation:Group-to-Group: 300V AC RMS
Channels: 8
Signal Type: 4–20 mA DC
nput Range:4–20 mA DC (configurable for 0–20 mA)
Overrange Capability: -1 mA to +25 mA
Input Impedance:≤ 250 Ω (typical)
Accuracy:±0.05% of span (at 25°C)
Temperature Drift:±0.005% of span/°C (-40°C to +70°C)
Resolution:24-bit
AO 8-CHANNEL 4-20MA HART CARD
12P4704X032
Channels: 8
Signal Type: 4–20 mA DC
Output Range:4–20 mA DC
Load Resistance:300–1100 Ω
Accuracy:±0.1% of span (25°C)
Temperature Drift:±0.02% of span/°C (-40°C to +70°C)
Resolution:15 bits (including sign)
Signal Type: 4–20 mA DC
Standard: 4–20 mA DC
Overrange: -5 mA to +25 mA
Input Impedance: ≤ 250 Ω (typical)
Field Power 30 VDC at 200 mA
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Response time :≥ 20 ms
Current input max. 0.6 A
Fuse (external) 10 A time-lag (T)
Back-up battery None
Operating voltage 24 VDC, -15...+20 %, rPP ≤ 15 %
Switching voltage 5 V, 250 VAC / 250 VDC
Number of channels 8 potential-free normally open contacts
Input voltage range : 18 to 30 VDC
No load on sensor side : ≤80 mA
20 mA load on sensor side : ≤120 mA
Output voltage dynamic range: 2 to 20 VDC
Output impedance : 20 Ω, protected against short-circuits
Power supply voltage rejection ratio
10 Hz to 400 Hz : ≥60 dB
400 Hz to 100 kHz : ≥30 dB
Output signal offset drift with temperature: ≤2 mV/°C
System Supply Voltage Range : 20 to 32V dc
Number of Inputs : 40 Channels
User Defined Thresholds : 4-off
Input Current Range : 0-22mA
Input Voltage Range : 0-6 Vdc
Resolution : 3.9uA (1/256mA)
Safety Accuracy : +/- 1% of full scale
Time-stamp Accuracy : ±0.5 ms
Sustained Working : ±250V dc
Maximum Withstanding : ±2.5kV dc
Channel to Channel Crosstalk : -40 to –60 dB
Power Consumption : 15 – 18W
Secure M2M communication
Local logic execution
Memory:1 GB RAM + 8 GB Flash
USB:1x USB 2.0 host port
Power Supply:12-24V DC
Processor:ARM Cortex-A9 dual-core @ 1.0 GHz
links MTL8000 node to Profibus-DP host LAN
supports up to 24 I/O modules
HART process & status variables over Profibus-DP
extended diagnostics for module and channel status
LAN speeds of up to 6 Mbaud
non-volatile memory for configuration
software configurable via local port or Profibus host
HART® maintenance via Comms adaptor
64532588
Interface Board
ADPI-01 PANEL INTERFACE
Power Supply:24V DC
Consumption: 15W (typical)
Operating Voltage:18–30V DC (±10%)
Isolation:500V AC between ports and power
