ABB are a market leading producer of power & automation technologies that enhance performance and reduce environmental impact for industries worldwide.
Amikon Limited stock and supply ABB motors, drives, programmable logic controllers (PLCs), power electronics and Robot spare parts and Discontinued card parts, motion and obsolete including variable speed drives, DC drives, PLCs and general automation spares.
ABB are a market leading producer of power & automation technologies that enhance performance and reduce environmental impact for industries worldwide.
Amikon Limited stock and supply ABB motors, drives, programmable logic controllers (PLCs), power electronics and Robot spare parts and Discontinued card parts, motion and obsolete including variable speed drives, DC drives, PLCs and general automation spares.
Pulse Signals: 0–24 V DC, 0–5 V DC
Isolation Voltage:1500–2500 V AC/DC
Signal Delay:≤ 100 ns
Power Supply:24 V DC
Power Consumption: ≤ 2 W
Operating Temperature:
-25°C to +70°C (-13°F to +158°F)
Storage Temperature:
-40°C to +85°C (-40°F to +185°F)
SDCSIOB21
DIGITAL INPUT/OUTPUT MODULE –24 VDC INCLUDES IOB-21 MODULE AND ONE RIBBON CABLE. REPLACES THE STANDARD DIGITAL INPUTS AND OUTPUTS WITH 8 DI/O POINTS EXTERNALLY MOUNTED WITH INPUT VOLTAGE LEVEL OF 24...48V DC. THE INPUTS ARE FILTERED AND GALVANICALLY ISOLA
Range: 19–30 V DC
Nominal Input: 24 V DC
Nominal Output: 24 V DC
Output Current: Up to 2.5 A
Power Rating: ~60 W (24 V x 2.5 A)
Ripple & Noise: <100 mV peak-to-peak
Isolation Voltage: 500 V AC
Operating Temperature: -25°C to +70°C (-13°F to +158°F)
Storage Temperature: -40°C to +85°C (-40°F to +185°F)
Program Memory:
128 kB Flash memory
64 kB RAM
Data Memory:
16 kB non-volatile memory for retain data
Power Supply Voltage: 24 V DC (±20%)
Operating Temperature:
Standard range: -25°C to +60°C
Storage Temperature:
-40°C to +85°C
PROFIBUS DP PROFIBUS-DPV1 fieldbus interface.
Supervisory functions of I/O ModuleBus
Isolated power supply to I/O modules
OSP handling and configuration
Input power fused
Hot Configuration In Run
HART pass-through
8 channels for RTD
(Pt100, Cu10, Ni100 and Ni120 and resistor) inputs
3-wire connection to RTDs
14 Bit resolution
Inputs are monitored for open-circuit,
shortcircuit and has a input grounded sensor
SDCS-PIN-51-COAT
Analog Inputs (AI):0–20 mA/4–20mA
PT100/RTD temperature
Channel Capacity: 8/16 channels
Resolution: ≥16-bit ADC
Sampling Rate: up to 1 kHz
Accuracy: ±0.1% of full scale
Operating Temperature: -25°C to +70°C
Humidity: Up to 95% non-condensing.
Analog Inputs: 2 channels
Analog Outputs: 2 channels
Digital Inputs: 6 channels
Digital Outputs: 3 relay outputs
Operating Temperature Range: -10°C to +55°C
Storage Temperature Range: -40°C to +70°C
Humidity: 5%-95% (non-condensing)
Protection Level: IP20
Analog: 0–10 VDC or 4–20 mA
Response Time: ≤1 ms
Accuracy: ±0.1% of full scale
Supply Voltage: 24 VDC (±10%) or 100–240 VAC
Power Consumption: ≤10 W (typical)
Operating Temperature: 0°C to +55°C (32°F to +131°F).
Humidity: 5–95% non-condensing.
Communication Protocol:MasterBus 300 (MB 300)
Ethernet Ports:2 x RJ45 (8-pin)
Transmission Speed:10 Mbit/s
Data Rate:200 Datasets/s
Operating Temperature:Up to 55°C
Protection Class:IP20 (according to EN60529, IEC 529)
Power Consumption:150 mA @ 24 VDC
8 channels for 0...20 mA, 4...20 mA
0...10 V or 2...10 V d.c.
single ended unipolar inputs
1 group of 8 channels isolated from ground
12 Bit resolution
Input shunt resistors protected to 30 V by PTC resistor
Analog inputs are short circuit secured to ZP or +24 V
The input withstand HART communication.
RAM: 512 MB of RAM
Operating Temperature: -5°C to +55°C
Storage Temperature:-25°C to +70°C
Humidity: humidity from 5% to 95%, non-condensing.
Power Supply: 24 VDC
