ALL MANUFACTURERS

TRIGGER CONTROL BOARD

DRIVER BOARD
TRIGGER CONTROL BOARD
SINAMICS PWB
1080 VDC
810-1025 AMP

Impedance capacitance plate

SIMOTRAS HD Snubber circuit 
Rated Voltage (Unm): 690 V AC (50/60 Hz)
Operating Voltage Range: 200–750 V AC
Capacitance: 10–50 μF
Impedance Range: 5–50 Ω at 50 Hz
Dielectric Strength: 2.5 kV AC

CONTROL BOARD

Input Voltage:24V DC (±10%, isolated)
Internal Logic:3.3V/5V TTL
Protections:Short-circuit
PCB: 6-layer design
Thermal Rating: 0°C to +55°C

INVERTER MOTHERBOARD

INVERTER MOTHERBOARD
FOR ACS580
3AXD50000716975
Input Voltage Range:380–500V AC (3-phase)
DC Bus Link:Integrated protection
Control Voltage:24V DC
Logic Board Power:Switch-mode PSU
Communication Isolation:1500V AC reinforced
Operating Temp:-15°C to +45°C 

Control Module

Analog: 2x 0–10V/4–20mA inputs
Digital: 8x programmable DI
Main circuit up to 690V AC
Functional isolation: ≥2.5kV
Thermal Resilience: ±55°C ambient

CONTROL BOARD

Input Voltage:380–690V AC
Output Power:up to 630 kW
Control Voltage:24V DC (±10%)
Ambient Operation:-15°C to +50°C
Humidity Protection:<95% non-condensing
CE Mark: Low Voltage Directive
Digital I/O: 6 programmable DI
Analog I/O: 2x 0–10V/4–20mA 

Panel holder mounting kit

Dynamic Load Rating: ≤5kg 
Operating Temperature:-30°C to +60°C
Material Safety:RoHS & REACH compliant
Fire Retardancy:UL94-V2
Spacer Bushings:Nylon PA66
Locking Nuts/Washers:Zinc-Plated

CONTROL UNIT

Input Power (AC):400–690V (±10%) 3-phase
Motor Power Range:250kW–1.5MW
Control Voltage:Single-phase 26V DC to 30V DC (±15%)
Operating Temp:-15°C to +50°C
Harsh Environment:UL 1203
Busbar Terminals:values 8.9Nm ±0.5
AS-Interface Safety ATEX Gateway

CONTROL UNIT

Input Voltage:200–690V AC (-15%/+10%)
Power Range:15–400kW
Control Voltage:Single-phase 24V DC
Relay Outputs:4 × Form-A 
AF-650PG: Profibus DP or CANopen

CURRENT MEAS.SCAL

Input Range:0–600A AC/DC
Output Range:±10V DC / 4–20mA
Isolation Voltage:2.5kV RMS 
Accuracy:±0.25% FS (25°C)
Bandwidth:DC – 10kHz 
Drift:<75ppm/°C
Response Time:<50µs
Hall Effect Sensor: 24V DC

Voltage Meas.Scaling Card

Rated Input Voltage:3300V AC/DC ±10%
Output Signal:±10V DC
Isolation Voltage:8kV RMS
Bandwidth:DC – 5kHz (-3dB)
Linearity Error:≤±0.15% FS
Drift:<50ppm/°C
Output Ripple:<5mV p-p at 50Hz
Response Time:<500µs for step inputs
Input Impedance: 1MΩ nominal

Starter kit

CPU:16-bit Renesas RX630 MCU
Memory:256KB RAM
Communication:2 × Ethernet (10/100BASE-T)
I/O Simulation:Virtual D/I and D/O
Power Supply:24V DC
6 × D/O (Transistor Sink: 0.5A @ 24V DC
Power cables :24V DC

POWER SUPPLY BOARD

AC Input Range: 200–500V AC
Frequency: 50/60Hz nominal 
Input Surge Withstand: 4kV
+24VDC Logic Supply: 4A continuous
±15VDC Gate Driver Supply: 0.5A per rail (±2% regulation)
Standby 5VDC: 2A 
Total Efficiency (85% load): ≥88%
Operating Temp: -25°C to +70°C

R9 Input Spare Kit

Low Voltage (LV): 380–480V AC
Optional High Voltage (HV):500–690V AC
Short-Circuit Current Rating (I_SC): ≤100 kA
Inrush Current Limit: ≤150% × rated input current
Isolation: ≥2.5 kV
Dynamic braking fuses:690V AC, 100–800A
Ambient Temp Range: -15°C to +45°C
Storage Humidity: ≤95% non-condensing

IGBT ASSEMBLY KIT

Category: Replacement IGBT Assembly Kit
Nominal Voltage (V_CE): 500V
Insulation Voltage: 2500V
Tjmax (ΔT over case): 70K

INVERTER BOARD

3BHE024855R0101
DISCONTINUED BY MANUFACTURER
INVERTER BOARD
UFC921 A101

Digital Output Baseplate

I/O Baseplate
I/O Interconnect Assembly
Slot Cover
Terminal Cover
Muber of Chanels: 24
Output Current: 2A
Output Voltage: 24VE
CA per channel
Power Consumption:20w

Digital Input Module

Points:4, commoned-return, DC-coupled
Output current range:
4–20 mA output, controlled
0–22 mA over-range
0 mA output capability (step function <2 mA)
Type:TMR
Resolution:12 bits
Diagnostic:Forced-switch diagnostic (FSD)
Over-range protection:36 V DC, continuous

Digital Input Module

Points:32, commoned
Nominal input voltage:24 V DC
Operational voltage range:15–30 V DC
Absolute maximum input voltage:33 V DC
Absolute maximum reverse input voltage:–0.6 V DC
Input delay:<10 ms, On to Off or Off to On
ADC scan time:<1 ms for all 32 points

Digital Output Module

Points:16, commoned
Nominal output voltage:24 V DC
Operational voltage range:15–30 V DC
Absolute maximum output voltage:33 V DC
Absolute maximum reverse input voltage:–0.6 V DC
Leakage to load (Off-state):<1 mA
On-state voltage drop:<1 V DC @ 1.5 A
Loop-back scan time:<1 ms for all 16 points

ANALOG INPUT MODULE

Points:32, commoned
Nominal input current:4–20 mA DC
Operational current range:2–22 mA DC
Absolute maximum field voltage:33 V DC
Absolute maximum input current:50 mA DC
Input bandwidth (3dB):16 Hz
Source impedance:180 Ω
Resolution:12 bits
Absolute error:0.15% of full scale (20 mA)
Diagnostic:Force-to-value diagnostic (FVD)
Scan time:<1 ms for all 32 points

Contact And Non-Contact Thermometer

Offers a distance-to-spot ratio of 50:1
Works with most K-type thermocouples
Allows easy access to advanced features 
with soft-key buttons and graphical display
Captures up to 99 points of data for 
quick downloading to a PC through the USB connection
Quickly identifies problems with MIN, MAX, AVG, and DIF functions
Easily adapts to lighting conditions with a two-level backlight

IGCT controller module

Reverse Voltage:4500V+
Forward Current:250–5000A
Switching Speed:<100 μC
Trigger Voltage/Current:+15/-15V pulses
Turn-On/Off Time:300–500 ns

THYRISTOR/DIODE MODULE

R8 SINGLE MODULE SP KIT
Forward Voltage: 1200–2500V range
Average On-State Current:500–2000A
Surge Current :10–50 kA
Isolation: ≥2000 V AC
Junction Temperature:>125°C

Conversion board

Supply Voltage:24V DC
Analog Inputs: 0–10 V / 4–20 mA
Communication Ports: Terminals for RS-485
Isolation Rating: ≥1500 V AC
Power Handling: 5-10A
Operating Temperature: -25°C to +70°C